GE JX1830SB Installation Instructions - Page 1
GE JX1830SB - 30" Deluxe Trim Manual
View all GE JX1830SB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installation Instructions Built-In Trim Kits JX1827 and JX1830 Questions? Call GE Answer Center at 800.626.2000 or Visit our Website at: www.GEAppliances.com BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the Consumer. • Note to Consumer - Keep these instructions for future reference. • Unplug the microwave oven before attempting installation of this kit. • Skill level - Installation of this appliance requires basic mechanical and electrical skills. • Completion time - 1-3 hours • Proper installation is the responsibility of the installer. • Product failure due to improper installation is not covered under the Warranty. • This kit is UL listed for installation alone or over any General Electric/Hotpoint/RCA single electric wall oven. FOR YOUR SAFETY: WARNING - Before beginning the installation, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. TOOLS YOU WILL NEED PARTS INCLUDED PART Trim Frame QUANTITY 1 Bottom Duct 1 Side Duct 1 Phillips screwdriver Pencil Awl or punch Drill with 7⁄64″ bit or #35 Tape measure READ CAREFULLY. KEEP THESE INSTRUCTIONS. 1 1" Screws 6 (4 required, 2 extra) 1/2" Screws 15 (11 required, 4 extra) Anti-Tip Bracket 1 Bottom Bracket 1 Upper Duct 1 Template 1