GE JX1830SB Installation Instructions - Page 3
Install Side Duct And Upper - installation instructions
View all GE JX1830SB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Installation Instructions 3. INSTALL THE ANTI-TIP BRACKET A Fold or cut the front edge of the template, along the front guide line. Place the template flush along the front edge of the cutout floor, aligning the center line of the template with the center line of the cutout floor. Mark the center positions with an awl or center punch for the anti-tip bracket location as shown. Cutout Floor B Remove the template and drill two holes for the anti-tip bracket. 1⁄2″ Screws (2) Anti-Tip Bracket C Install the anti-tip bracket onto the cutout floor using two 1⁄2″ screws. 4. INSTALL SIDE DUCT AND UPPER DUCT A Connect the side duct to the upper duct as shown. 1. Insert projecting tabs of the upper duct into the holes of the side duct. 2. Bend the tabs up with caution as shown. NOTE: Remove any oil or dirt on the surface of the microwave oven before the ducts are attached. Upper Duct 3 Holes 3 Tabs (1) Side Duct (2) B Set the microwave upright, being careful not to bend the front flange. Remove the one existing screw from the left side of the microwave oven. C Peel off the backing of the double sided tape. Carefully position the side duct and upper duct assembly on the microwave cabinet, aligning with the bottom screw hole. Press down firmly on the ducts. Fasten the duct assembly to the left side of the cabinet with the screw removed above. Existing Screw (1) 3