GE NX-591E-GSM Instruction Manual - Page 15

11 Location 2, events to report to central station Phone fault detected. This location has 16 segments. Note: Reporting must be enabled in the control panel for this location to function. This location selects the partitions to include when reporting to the central station. To exclude any partition from reporting, turn off the LED corresponding to that particular partition number. Enter the numbers of the partitions to include for each type of report found in segments 1 through 16. Factory default is all partitions on for segment 1; all partitions off for segments 2 to 16. Table 7 describes the segment options. Table 7. Location 2 options Segment 1 2 3 4 5 6 7 8 Description Alarms Open/close Bypass Zone trouble Power trouble (AC failure or low battery) Siren and telephone fault Test reports Program, download, and log full Segment 9 10 11 12 13 14 15 16 Description Tampers Short circuit and ground fault Sensor lost Sensor low battery Expander trouble Failure to communicate Zone activity monitor Reserved for future use. Location 3, special events to report to central station Phone fault detected. This location has 8 segments. This location selects the partitions to include when reporting special events to the central station. To exclude any partition from reporting, simply turn off the LED corresponding to that particular partition number. Enter the numbers of the partitions to include for each type of report found in segments 1 through 4. Factory default is all partitions off for segment 1 and 3; all partitions on for segments 2 and 4. Segments 5 to 8 are reserved for future use. Table 8 describes the segment options. Table 8. Location 3 options Segment Description 1 Alarm restores 2 Telephone fault Segment 3 4 Description Start download Fail to communicate, data lost