GE PDW7800P Owners Manual - Page 5
Consumer Support, Troubleshooting Tips, Safety Instructions, Operating Instructions
View all GE PDW7800P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Safety Instructions Operating Instructions ge.com SPEED CYCLE (on some models) CHINA CRYSTAL or HAND/GENTLE GLASSES (on some models) RINSE ONLY or RINSE & HOLD 7.5 gal. (28.4 l), 35 min. This cycle is for everyday dishes and glassware. 7.5 gal. (28.4 l), 35 min. This cycle is for lightly soiled china and crystal. 7.5 gal. (28.4 l), 35 min. This cycle is specifically designed for glasses. 2.5 gal. (9.5 l), 10 min. For rinsing partial loads that will be washed later. Do not use detergent with this cycle. NOTE: The CHINA CRYSTAL/PLASTICS (some models) selector is a toggle pad; toggle the pad until the desired cycle is indicated. NOTE: This dishwasher is equipped with a CleanSensor™ with automatic temperature control; therefore, cycle length and time may vary depending on soil and temperature conditions. NOTE: Only the Anti-Bacteria cycle has been designed to meet the requirements of Section 6, NSF 184 for soil removal and sanitization efficacy. 4 Enhancements/Extras The light above the selected pad will be ON to indicate which ENHANCEMENT/EXTRA has been selected. PRE WASH For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be (on some models) selected PRIOR to starting the cycle. This option adds 16 minutes to the cycle time. NOTE: Cannot be selected with RINSE ONLY cycle. HEATED DRY When HEATED DRY is off, dishes will air dry. Light OFF HEATED DRY Light ON Turns the heater on for faster drying. This will extend the total cycle time between 8 and 38 minutes depending on the cycle selected. NOTE: HEATED DRY cannot be selected with RINSE ONLY cycle. LOCK You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a cycle. Children cannot accidentally start dishwasher by touching pads with this option selected. To unlock the dishwasher controls, touch and hold the HEATED DRY pad for 3 seconds. The light above the LOCK pad will turn off. To lock the dishwasher, touch and hold the HEATED DRY pad for 3 seconds. The light above the LOCK pad will turn on. ADDED HEAT or EXTRA HOT WASH or TEMP BOOST (on some models) When selected, the cycle will run with heating element on longer and may increase cycle times to improve both wash and dry performance. NOTE: Cannot be selected with RINSE ONLY cycle. DELAY HOURS You can delay the start of a wash cycle for up to 9 hours. Touch the DELAY HOURS pad to choose the number of hours you want to delay the start of the cycle; then touch START/RESET. The machine will count down and start automatically at the correct time. Touching START/RESET a second time will cancel the DELAY START selection. NOTE: If you forget to fully close the door, a reminder signal will beep until you do so. RESET To change a cycle after washing starts, touch the START/RESET pad to cancel the cycle. The START/RESET light will flash while the water is pumped out if needed. This takes approximately 90 seconds. When the light stops flashing, the dishwasher can be reprogrammed and restarted. Troubleshooting Tips Consumer Support 5