GE PGSS5PJY Owners Manual - Page 10
About the freezer
View all GE PGSS5PJY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Operating Instructions Safety Instructions About the freezer. Not all features are on all models. Freezer Shelves and Baskets A shelf above the ice storage bin A full-width upper basket in top drawer An ice storage bin Appearance and features may vary A shallow full-width upper basket in bottom drawer A deep full-width lower basket in bottom drawer Appearance may vary Tab Basket Removal (Top Drawer) To remove the full-width basket on top freezer drawer models: Open the top freezer drawer until it stops. The freezer basket rests on the inside tabs on the drawer slides. Lift the front end of the basket so that the front two alignment tabs come out of the slide bracket first. Then rotate the front edge of the basket up while lifting the remaining two rear alignment tabs out of the slide bracket. Make sure the plastic sleeves remain attached to the 4 slots on the slide brackets. When replacing the full-width basket: Tilt the basket back and lower it down into the drawer. Rotate the basket to a horizontal position and press it down into the 4 alignment tabs. NOTE: Always be sure that all 4 basket slots are engaged in the slide brackets before sliding back into the freezer. Installation Instructions Consumer Support Troubleshooting Tips Appearance may vary Appearance may vary Basket Removal (Bottom Drawer) To remove the full-width upper basket: Open the bottom freezer drawer until it stops. Pull the basket out to the stop location. Lift the basket up at the front to release it from the slides. Lift the back up and out of the slide. When replacing the full-width upper basket: Drop the upper rear wire rail of the basket into place behind the plastic tabs. Then drop the front end of the basket into place and slide the basket back into the closed position. NOTE: Always be sure to fully close this basket. To remove the deep full-width lower basket: Open the bottom freezer drawer until it stops. Lift the rear of the basket up so the two rear alignment tabs are pulled out of the slide bracket. Rotate the basket up and out of the drawer. When replacing the deep full-width lower basket: Lower the front end of the basket into position so that the two front alignment tabs enter the slide bracket. Then lower the rear of the basket into place, ensuring the two rear alignment tabs are pressed into place in the slide bracket. NOTE: Always be sure that all 4 basket slots are engaged in the slide brackets before sliding back into the freezer. 10