GE PSA1201RSS Installation Instructions - Page 18

Installation Instructions B5 MOUNT THE OVEN FOR EASIER INSTALLATION AND PERSONAL SAFETY, WE RECOMMEND THAT TWO PEOPLE INSTALL THIS OVEN. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from over tightening screws. NOTE: When mounting the oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1 Lift oven, tilt it forward, and hook slots at back bottom edge onto two lower tabs of mounting plate. Cabinet Front Cabinet Bottom Shelf Filler Block Equivalent to Depth of Cabinet Recess Self-Aligning Screw Oven Top 4 Attach the oven to the top cabinet. 5 Insert 2 self-aligning screws (1⁄ 4″-28 x 31⁄ 4″) through outer top cabinet holes. Turn two full turns on each screw. 6 Tighten center screw completely. NOTE: Use self-aligning screw, 1⁄4″-28 x 25⁄8″, on PVM1790 and self-aligning screws, 1⁄4″-28 x 31⁄4″, on PSA1200 and PSA2200. 7 Tighten the outer two screws to the top of the oven. (While tightening screws, hold the oven in place against the wall and the top cabinet.) 2 Rotate front of oven up against cabinet bottom. 3 Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet. 8 Install grease filters. See the Owner's Manual packed with the oven. 18