GE PSA1201RSS Installation Instructions - Page 22

Installation Instructions C4 MOUNT THE OVEN (continued) 5 Insert 2 self-aligning screws (1⁄ 4″-28 x 31⁄ 4″) through outer top cabinet holes. Turn two full turns on each screw. C5 INSTALLING THE CHARCOAL FILTER 1 Remove 2 screws on top of oven, just above the grille panel, using a Phillips screwdriver. 2 Open the door. 3 Remove the grille. Screws Grille 6 Tighten center screw completely. NOTE: Use self-aligning screw, 1⁄4″-28 x 25⁄8″, on PVM1790 and self-aligning screws, 1⁄4″-28 x 31⁄4″, on PSA1200 and PSA2200. 7 Tighten the outer two screws to the top of the oven. (While tightening screws, hold the oven in place against the wall and the top cabinet.) 4 Insert the filter into the oven as shown until it fits squarely into place. It will rest at an angle behind the front lower tabs. When properly installed, the wire mesh of the filter should be visible from the front. Front lower tabs 8 Install grease filters. See the Owner's Manual packed with the oven. Charcoal filter Charcoal filter installed 5 Replace the grille and the 2 top screws. 6 Close the door and replace left side screw. 22