GE PSB1200NWW Installation Instructions - Page 11
Installation under a GE/Monogram, Microwave Oven and over a Warming, Drawer, Installation over
UPC - 084691188780
View all GE PSB1200NWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE 36-3/4″. MODEL ZSC1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING (cont.) Installation over another GE/Monogram Under-the-Counter (UTC) oven: 30″ 23-1/2″ 25-1/4″ 21″ Construct Solid Bottom Min. 3/8″ Plywood Supported by 2 x 4 or 2 x 2 Runners all Four Sides 2″ Min. (3″ Recommended) PREPARE THE OPENING (cont.) Installation under a GE/Monogram Microwave Oven and over a Warming Drawer: 30″ 23-1/2″ 25-1/4″ Per Oven Requirement Construct Solid Bottom Min. 3/8″ Plywood Supported by 2 x 4 or 2 x 2 Runners all Four Sides 3.5″ Min. (4.5″ Recommended) 21″* *Profile models only • If you are mounting an Under-the-Counter GE/Monogram oven over another, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 2″ minimum shown. 21″* Per Warming Drawer Requirement 2″ Min. (3″ Recommended) *Profile models only NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height. See Warming Drawer installation instructions for details. CAUTION: For personal safety, the mounting surface must be capable of supporting the cabinet load, in addition to the added weight of this approximate 80-pound oven, plus additional oven loads of up to 50 pounds or a total weight of 130 pounds. 11