GE PSB1200NWW Installation Instructions - Page 9

Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE 36-3/4″. MODEL ZSC1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING (cont.) The Advantium 120V can be installed in combination with other GE/Monogram appliances. Always follow each product's Installation Instructions to complete the installation. Single Advantium 120V Installation: Order a 30″ wide single oven cabinet or cut the opening in a wall to the dimensions shown. 30″ 23-1/2″ PREPARE THE OPENING (cont.) Installation over a GE/Monogram Warming Drawer: 30″ 23-1/2″ 25-1/4″ Min. Construct Solid Bottom Min. 3/8″ Plywood Supported by 2 x 4 or 2 x 2 Runners all Four Sides 25-1/4″ Min. 21″ 21″ 36-3/4″ Min.* 2″ Min. (3″ Recommended) Per Warming Drawer Requirement 36-3/4″ Min.* Construct Base Min. 3/8″ Plywood Supported by 2 x 4 or 2 x 2 Runners all Four Sides *Required for Monogram models • Allow 2-1/8″ case trim overlap on the sides, 1-1/16″ overlap on the top and 7/8″ overlap on the bottom of the opening for all models. • Oven overlaps will conceal cut edges on all sides of the opening. When installed over a single oven or a warming drawer, allow at least 2″ between the two openings. This separation will provide clearance for bottom overlap of the Advantium 120V and the other appliance overlaps. Construct a solid oven floor of 3/8″ min. thick plywood supported by 2 x 4 or 2 x 2 runners on all sides. • The support must be level and rigidly mounted, flush with the bottom edge of the cutout. *Required for Monogram models NOTE: Additional clearances between the cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height. See Warming Drawer installation instructions for details. 9