GE PSCS3RGXSS Use and Care Manual - Page 37

Safety Instructions Operating Instructions ge.com Installation Instructions Problem Possible Causes What To Do Frequent "buzzing" sound Icemaker power switch is in the • Set the power switch to the O (off) position. Keeping it in I (on) position, but the water supply the I (on) position will damage the water valve. to the refrigerator has not been connected. Ice cubes have odor/taste Ice storage bin needs cleaning. • Empty and wash bin. Discard old cubes. Food transmitting odor/taste to ice cubes. • Wrap foods well. Interior of refrigerator needs cleaning. • See Care and cleaning. Small or hollow cubes Water filter clogged. • Replace filter cartridge with new cartridge or with plug. Slow ice cube freezing Door left open. • Check to see if package is holding door open. Temperature control not set cold enough. • See About the controls. Cube dispenser does not work Icemaker turned off or water supply turned off. • Turn on icemaker or water supply. An item is blocking or has fallen into the ice chute inside the top door bin of the freezer. • Remove any item that might be blocking, or has fallen into the chute. Ice cubes are frozen to icemaker feeler arm. • Remove cubes. Irregular ice clumps in storage container. • Break up with fingertip pressure and discard remaining clumps. • Freezer may be too warm. Adjust the freezer control to a colder setting, one position at a time, until clumps do not form. Dispenser is LOCKED. • Press and hold the LOCK or LOCK CONTROLS pad for 3 seconds. Water has poor taste/odor Water dispenser has not been used for a long time. • Dispense water until all water in system is replenished. Water in first glass is warm Normal when refrigerator is first installed. • Wait 24 hours for the refrigerator to completely cool down. Water dispenser has not been used for a long time. • Dispense water until all water in system is replenished. Water system has been drained. • Allow several hours for replenished supply to chill. Water dispenser does not work Water supply line turned off or not connected. • See Installing the water line. Water filter clogged. • Replace filter cartridge or remove filter and install plug. Air may be trapped in the water system. • Press the dispenser arm for at least two minutes. Dispenser is LOCKED. • Press and hold the LOCK or LOCK CONTROLS pad for 3 seconds. Water spurting from dispenser Newly-installed filter cartridge. • Run water from the dispenser for 3 minutes (about one and a half gallons). Water is not dispensed but icemaker is working Water in reservoir is frozen. • Call for service. Refrigerator control setting is too cold. • Set to a warmer setting. No water or ice cube production Supply line or shutoff valve is clogged. • Call a plumber. Water filter clogged. • Replace filter cartridge or remove filter and install plug. Dispenser is LOCKED. • Press and hold the LOCK or LOCK CONTROLS pad for 3 seconds. CUBED ice was selected but Last setting was CRUSHED. CRUSHED ice was dispensed • A few cubes were left in the crusher from the previous 37 setting. This is normal. Troubleshooting Tips Consumer Support