GE PSCS3RGXSS Use and Care Manual - Page 9

About QuickFreeze., About the water filter.

Page 9 highlights

Safety Instructions Operating Instructions About QuickFreeze.™(on some models) QuickFreeze Plate The QuickFreeze plate is only to be used with the QuickFreeze feature. Use QuickFreeze to freeze items faster to enhance food preservation. How to Use Place food (wrapped in plastic wrap) on QuickFreeze plate. Turn the feature on via the LCD controls. ge.com Some LCD Models Only: Access By: Home > Options > Freezer Options > QuickFreeze Activate By: Using the arrows to select the time and pressing Enter. Deactivate By: Pressing OFF. NOTE: While the QuickFreeze feature is enabled, the actual freezer temperature may drop as low as -3°F (-19°C). This is normal. Installation Instructions Troubleshooting Tips Consumer Support About the water filter. Cartridge Holder Place the top of the cartridge up inside the cartridge holder and slowly turn it to the right. Filter Bypass Plug SmartWater Water Filter Cartridge The water filter cartridge is located in the back upper right corner of the refrigerator compartment. When to Replace the Filter LCD Models: A pop-up screen will appear on the LCD screen to remind you to replace the water filter. You can check the status of the water filter manually. Access By: Home > Options > Dispenser Options > Reset Water Filter Non-LCD Models: There is a replacement indicator light for the water filter cartridge on the dispenser. This light will turn orange to tell you that you need to replace the filter soon. The filter cartridge should be replaced when the replacement indicator light turns red or if the flow of water to the dispenser or icemaker decreases. Removing the Filter Cartridge If you are replacing the cartridge, first remove the old one by slowly turning it to the left. Do not pull down on the cartridge. A small amount of water may drip down. Installing the Filter Cartridge There is an adapter attached to the top of the new filter cartridge. The adapter must be removed before installing the cartridge. To remove the adapter, turn it to the left about 1/4 turn. Fill the replacement cartridge with water from the tap to allow for better flow from the dispenser immediately after installation. Line up the arrow on the cartridge and the cartridge holder. Place the top of the new cartridge up inside the holder. Do not push it up into the holder. Slowly turn it to the right until the filter cartridge stops. DO NOT OVERTIGHTEN. As you turn the cartridge, it will automatically raise itself into position. The cartridge will rotate about 1/2 turn. Run water from the dispenser for 5 minutes to clear the system and prevent sputtering. LCD Models: Press FILTER REPLACED button to confirm replacement. Non-LCD Models: Press the SET FEATURES pad until REPLACE WATER FILTER is lit. Press and hold the ON/OFF pad for 3 seconds. WATER FILTER IS RESET will show in the window. NOTE: A newly installed water filter cartridge may cause water to spurt from the dispenser. Filter Bypass Plug You must use the filter bypass plug when a replacement filter cartridge is not available. The dispenser and the icemaker will not operate without the filter or filter bypass plug. Replacement Filters: To order additional filter cartridges in the United States, visit our Website, ge.com, or call GE Parts and Accessories, 800.626.2002. MSWF Suggested Retail $36.95-$41.95 USD Customers in Canada should consult the yellow pages for the nearest Mabe Service Center. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132

About QuickFreeze.
(on some models)
ge.com
The
QuickFreeze
plate is only to be
used with the
QuickFreeze
feature.
Use
QuickFreeze
to freeze items faster
to enhance food preservation.
How to Use
Place food (wrapped in plastic wrap)
on
QuickFreeze
plate. Turn the feature
on via the LCD controls.
Some LCD Models Only:
Access By:
Home > Options > Freezer Options
> QuickFreeze
Activate By:
Using the arrows to select
the time and pressing
Enter
.
Deactivate By:
Pressing
OFF
.
NOTE:
While the
QuickFreeze
feature is
enabled, the actual freezer temperature may
drop as low as –3°F (–19°C). This is normal.
Consumer Support
Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation
Instructions
About the water filter.
Water Filter Cartridge
The water filter cartridge is located in
the back upper right corner of the refrigerator
compartment.
When to Replace the Filter
LCD Models:
A pop-up screen will appear on the LCD screen
to remind you to replace the water filter. You can
check the status of the water filter manually.
Access By:
Home > Options > Dispenser Options >
Reset Water Filter
Non-LCD Models:
There is a replacement indicator light for the water
filter cartridge on the dispenser. This light will turn
orange to tell you that you need to replace the
filter soon.
The filter cartridge should be replaced when the
replacement indicator light turns red or if the flow
of water to the dispenser or icemaker decreases.
Removing the Filter Cartridge
If you are replacing the cartridge, first remove
the old one by slowly turning it to the left.
Do not
pull down on the cartridge. A small amount of
water may drip down.
Installing the Filter Cartridge
There is an adapter attached to the top
of the new filter cartridge.
The adapter must be removed before
installing the cartridge. To remove the
adapter, turn it to the left about 1/4 turn.
Fill the replacement cartridge with water
from the tap to allow for better flow from
the dispenser immediately after installation.
Line up the arrow on the cartridge and
the cartridge holder. Place the top of the new
cartridge up inside the holder.
Do not
push
it up into the holder.
Slowly turn it to the right until the filter
cartridge stops.
DO NOT OVERTIGHTEN.
As you turn the cartridge, it will automatically
raise itself into position. The cartridge will
rotate about 1/2 turn.
Run water from the dispenser for 5 minutes
to clear the system and prevent sputtering.
LCD Models:
Press
FILTER REPLACED
button to confirm
replacement.
Non-LCD Models:
Press the
SET FEATURES
pad until
REPLACE
WATER FILTER
is lit. Press and hold the
ON/OFF
pad for 3 seconds.
WATER FILTER
IS RESET
will show in the window.
NOTE:
A newly installed water filter cartridge may
cause water to spurt
from the dispenser.
Filter Bypass Plug
You must use the filter bypass plug when a
replacement filter cartridge is not available.
The dispenser and the icemaker will not operate
without the filter or filter bypass plug.
Replacement Filters:
To order additional filter cartridges in the United
States, visit our Website, ge.com, or call GE Parts
and Accessories, 800.626.2002.
MSWF
Suggested Retail $36.95–$41.95 USD
Customers in Canada should consult the yellow
pages for the nearest Mabe Service Center.
Place the top of the cartridge up
inside the cartridge holder and
slowly turn it to the right.
QuickFreeze
Plate
Filter
Bypass
Plug
SmartWater
Cartridge
Holder
9