GE WCVH6800JWW Use and Care Manual - Page 8

Operating Instructions Safety Instructions About the washer features. noTE: Features may not be available on all washer models. 7 Cycle Signal Use the SIGNAL button to change the volume of the end of cycle signal. Press the button until you reach the desired volume. Installation Instructions 8 9 10 11 12 HOLD 3 SEC TO STORE MY CYCLE 13 8 Prewash (on some models) Prewash is an extra wash before the main wash. Use it for heavily soiled clothes or for clothes with a care label that recommends prewashing before washing. Be sure to add high-efficiency detergent, or the proper wash additive to the prewash dispenser. NOTE: When selecting prewash, it is recommended to use powder detergent in the main wash (detergent) compartment . Extra Rinse Use an extra rinse when additional rinsing is desired to remove excess dirt and detergent from soiled loads. Delay Start (on some models) You can delay the start of a wash cycle for 10-18 hours, depending on the model. Press the DELAY START button to choose the number of hours you want to delay the start of the cycle, then press the START button. The machine will count down and start automatically at the correct time. NOTE: If you forget to fully close the door, a reminder signal will beep reminding you to do so. NOTE: If you open the door when the delay is counting down, the machine will enter the pause state. You must close the door and press START again in order to restart the countdown. Lock You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a cycle. children cannot accidentally start the washer by touching pads with this option selected. MY CYCLE (on some models) To save a favorite cycle, set the desired settings for wash cycle, soil level, spin speed and wash temp settings and hold down the MY CYCLE button for 3 seconds. A beep will sound to indicate the cycle has been saved. To use your custom cycle, press the MY CYCLE button before washing a load. To change the saved cycle, set the desired settings and hold down the MY CYCLE button for 3 seconds. To lock the washer, press and hold the DELAY START button for 3 seconds (on some models use SIGNAL button). To unlock the washer controls, press and hold the DELAY START button for 3 seconds. The control lock icon on the display will light up when it is on. NOTE: The POWER button can still be used when the machine is locked. NOTE: When using MY CYCLE, wash options cannot be modified after the cycle has been started. NOTE: If you change wash options with MY CYCLE before starting the cycle, the MY CYCLE light will turn off and you will be returned to the base cycle. BASKET CLEAN BasketClean is a cycle that freshens up the inside of your washer. The cycle uses bleach or other available washing machine cleaners and more water to refresh your washer. Use BasketClean once every month to reduce odor and residue buildup inside the washer. For more information on BasketClean, refer to the care and cleaning section on page 12. Consumer Support Troubleshooting Tips