Genie DirectLift Owner's Manual - Page 6

Warning, Important, Safety Instructions - installation manual

Page 6 highlights

Ch e c k Step 8: Recommended tools A Tools (Figure 8): B Additional tools to make installation easier: • Slotted and phillips screw-driver bits • Stud finder • Sheet-metal cutting snips Ch e c k S teD p 9: Remove Existing Garage Door Locks Check that the garage door locks, rope, and T-Handles are removed from the garage door before starting the installation. A If your garage does not have a separate entry door, it is highly recommended to install a Genie Emergency Release Kit (GER-2). Emergency Release Kit lets you open the garage door from outside if there is a ppower failure. (Please see Accessories Order Form on page 14.) Before going further, get any items and tools if needed for your installation p Garage door frame reinforcement brackets, screws, bracing or reinforcement kits (dealer) p Lag Screws (1-1/4") for a wood door less than 2" thick (store) p Electrical outlet and/or wiring (supplied by a licensed electrician) p Sufficient angle iron or strapping for hanging Power Head (store) p 60 Watt light bulbs (Rough service bulbs recommended)(store) p GER-2 Emergency Release Kit for entry during power failure (store) p Wood for header, ceiling, and/or door braces (store) p Masonry fasteners for Safe-T-Beam® Bracket installation (store) p Safe-T-Beam® Bracket Extensions (dealer) p Masonry drill bit (store) p Extension Kit (for 8' Garage Doors)(dealer) IMPORTANT SAFETY INSTRUCTIONS WARNING: TO REDUCE THE RISK OF SEVERE INJURY OR DEATH 1 READ AND FOLLOW ALL INSTRUCTIONS. 2 Never let children operate or play with the Door Controls. Keep the Remote Control away from children. 3 Always keep the moving door in sight and away from people and objects until the door is completely closed. NO ONE SHOULD CROSS THE PATH OF A MOVING DOOR. 4 NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR. 5 Test Opener monthly. The door MUST reverse on contact with a 1-1/2" high object (or a 2" x 4" board laid flat) at the center of the doorway on the floor. After adjusting either the Force or the Limit of travel, retest the Door Opener. Failure to adjust the Opener properly may cause severe injury or death. 6 When possible use the Emergency Release only when the door is closed. Use caution when using this Release with door open. Weak or broken springs are capable of increasing the rate of door closure and increasing the risk of severe injury or death. 7 KEEP GARAGE DOORS PROPERLY BALANCED. See Owner's Manual. An improperly balanced door increases the risk of severe injury or death. Have a Genie Factory Authorized Dealer make repairs to cables, spring assemblies, and other hardware. 8 SAVE THESE INSTRUCTIONS. NOTES, REMINDERS Go to Assembly and Installation Poster for full Installation Instructions. Figure 8 Recommended Tools 6 For Help, call 1-800-35-GENIE or visit www.geniecompany.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14

For Help, call 1-800-35-GENIE or visit www.geniecompany.com
6
Figure 8
Recommended Tools
Go to Assembly and Installation Poster for full
Installation Instructions.
R
ECOMMENDED
TOOLS
A
Tools (
Figure 8
):
B
Additional tools to make installation easier:
Slotted and phillips screw-driver bits
Stud finder
Sheet-metal cutting snips
Check Step 8:
R
EMOVE
E
XISTING
G
ARAGE
D
OOR
L
OCKS
Check that the garage door locks, rope, and T-Handles are
removed from the garage door before starting the installation°
A
If your garage does not have a separate entry door, it is
highly recommended to install a Genie Emergency Release
Kit (
GER-2
Emergency Release Kit lets you open the garage
door from outside if there is a ppower failure°
(Please see
Accessories Order
Form on page 14°)
Check Step 9:
Before going further, get any items and tools if needed
for your installation
p
Garage door frame reinforcement brackets, screws, bracing
or reinforcement kits (dealer)
p
Lag Screws (1-1/4”) for a wood door less than 2” thick (store)
p
Electrical outlet and/or wiring (supplied by a licensed electrician)
p
Sufficient angle iron or strapping for hanging Power Head (store)
p
60 Watt light bulbs (Rough service bulbs recommended)(store)
p
GER-2 Emergency Release Kit for entry during power failure (store)
p
Wood for header, ceiling, and/or door braces (store)
p
Masonry fasteners for Safe-T-Beam® Bracket installation (store)
p
Safe-T-Beam® Bracket Extensions (dealer)
p
Masonry drill bit (store)
p
Extension Kit (for 8’ Garage Doors)(dealer)
WARNING:
TO REDUCE THE RISK OF
SEVERE INJURY OR DEATH
IMPORTANT
SAFETY INSTRUCTIONS
1
READ AND FOLLOW ALL INSTRUCTIONS°
2
Never let children operate or play with the Door Controls°
Keep
the Remote Control away from children°
3
Always keep the moving door in sight and away from people and
objects until the door is completely closed°
NO ONE SHOULD CROSS THE PATH OF A MOVING DOOR°
4
NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR°
5
Test Opener monthly°
The door MUST reverse on contact with
a 1-1/2” high object (or a 2” x 4” board laid flat) at the center of the
doorway on the floor°
After adjusting either the Force or the Limit
of travel, retest the Door Opener°
Failure to adjust the
Opener
properly may cause severe injury or death°
6
When possible use the Emergency Release only when the door
is closed°
Use caution when using this Release with door open°
Weak or broken springs are capable of increasing the rate of door
closure and increasing the risk of severe injury or death°
7
KEEP GARAGE DOORS PROPERLY BALANCED°
See Owner’s
Manual°
An improperly balanced door increases the risk of
severe
injury or death°
Have a Genie Factory Authorized Dealer make
repairs to cables, spring assemblies, and other hardware°
8
SAVE THESE INSTRUCTIONS.
NOTES, REMINDERS