Genie DirectLift Owner's Manual - Page 8

Transmitter Compliance Statement Accessories Pr o g ra m m ing 1C: Programming the Remote Controls Ad ju s t m en t 2 : Ch Setting Contact Reverse Function NOTE Limit Switch and Force Adjustments must be completed before checking the contact reverse function (Figure MA-3). A Open garage door using Wall Console. Figure MA-3 B Lay a 2" x 4" board flat in center of doorway. C Close door using Wall Console. D Check that door stops and reverses within 2 seconds after it contacts board: • If door does not reverse, decrease Close Force until door reverses. • If door still does not reverse, move Limit Switch toward door. E Check Safe-T-Beam® System operation: • If beam is not close. blocked, door will 2" x 4" b oard laid flat NOTE The door must contact the 2" x 4" board before the Carriage activates the Close Limit Switch. If not, readjust the Close Limit Switch. NOTE • Each Remote Control must be programmed separately. • The Remote Controls will not cause the door Opener to close the garage door if the Safe-T- Beam® System is malfunctioning. • When programming the Remote Controls, they must be at least 24" from the Antenna Wire. • If the red Learn Indicator Light blinks approximately 4 times per second, programming has stopped. If programming has stopped, repeat the above steps. • Each Button on a 2 or 3 Button Remote Control is for a different Opener. You cannot use more than one Button per Remote, per Opener. • A maximum of seven Remote Controls or Wireless Keypads can be stored into the Receiver at one time. If a Remote Control becomes lost, or if you want to delete a Remote Control or Wireless Keypad, see "To Erase All Receiver Memory." A To program one Button of a Remote Control (Figure MA-4): • Locate Learn Button and Learn Indicator Light on left side of Power Head (Figure MA-5). • Press and release Learn Button. Red Learn Indicator Light will blink 2 times per second. • Press Remote Control Button once within 30 seconds. Red Learn Indicator Light will stay lit. • Press Remote Control Button again. Red Learn Indicator Light will go out, indicating that memory is stored. B Program each additional Remote using step A above (up to seven). To Erase All Remotes from Power Head Memory A Press and hold Learn Button on Power Head for 10 seconds or until Learn Indicator Light goes out. Memory is erased: • Program Transmitter/Receiver again as needed. To Replace Remote Control Battery A FOR NON-FLASHLIGHT MODELS • Pop off the back of the transmitter. - Use coin, pen, screwdriver or any similar device. - Replace old Battery with new coin type battery. • Replace back of remote. B FOR FLASHLIGHT MODELS • Slide open battery cover. - Replace old Battery with new AAA battery. • Replace battery cover. 8 For Help, call 1-800-35-GENIE or visit www.geniecompany.com