Gigabyte 7VM400AM-RZ User Manual - Page 33
Set Supervisor/User Password
View all Gigabyte 7VM400AM-RZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
English Set Supervisor/User Password CMOS Setup Ut ility-Co pyright (C) 1984 -2004 Aw ard Soft ware } Stan dard CM OS Feat ures } Adva nced BI OS Feat ures } Inte grated Periphe rals } Powe r Manag ement S etup } PnP/ PCI Con figuratEinotnesr Passw ord: } PC H ealth St atus } Frequ ency/Vol tage Con trol Load Fail-Sa fe Defa ults Load Optimiz ed Defa ults Set Supervis or Pass word Set U ser Pass word Save & Exit S etup Exit Without S aving ESC: Quit F8: Q- Flash higf: Selec t Item F10: Save & Exit S etup Chang e/Set/Dis able Pas sword When y ou select this function, the follow ing message w ill appear at the center of the screen to assist y ou in creating a pas sw ord. Ty pe the passw ord, up to eight characters, and press . You will be asked to confirm the passw ord. Ty pe the passw ord again and press . You may also press to abort the selection and not enter a passw ord. To disable pass w ord, jus t press w hen y ou are prompted to enter pass w ord. A mess age "PASSWORD DISABLED" w ill appear to confirm the pass w ord being disabled. Once the passw ord is disabled, the sy stem w ill boot and y ou c an enter Setup freely . The BIOS Setup program allow s y ou to specify tw o separate passw ords: SUPERVISOR PASSWOR D and a USER PASSWORD. When disabled, any one m ay access all BIOS Setup program function. When enabled, the Superv is or passw ord is required for entering the BIOS Setup program and hav ing full configuration fields, the User passw ord is required to access only basic ite ms. If y ou select "Sy stem" at "Passw ord Check" in Adv anc e BIOS Features Menu, y ou w ill be prompted for the passw ord ev ery time the sy stem is rebooted or any time y ou try to enter Setup Menu. If y ou select "Setup" at "Passw ord Check" in Adv ance BIOS Features Menu, y ou w ill be prompted only w hen y ou try to enter Setup. - 33 - BIOS Setup