Gigabyte GA-7PESLX Manual - Page 27
SATA2/SATA3/SATA4/SATA5 SATA 3Gb/s Connectors, SATA0/SATA1 SATA 6Gb/s Connectors
View all Gigabyte GA-7PESLX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
DEBUG DEBUG PORT PORT 11) SATA2/SATA3/SATA4/SATA5 (SATA 3Gb/s Connectors) 12) SATA0/SATA1 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and 1.5Gb/s standard. Each SATA connector supports a single SATA device. SATA0 SATA1 When SATA_DOM1/2 jumper are set to Normal Mode: GA-7PESL SATA0 SATA1 7 7 1 1 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND SATA5 SATA4 SATA3 SATA2 SATA0 SATA1 When SATA_DOM1/2 Jumper are set to 1-2 pin: Pin No. Definition 1 GND 2 TXP 3 TXN 4 GND 5 RXN 6 RXP 7 P5V GA-7PESLX GA-7PESLN SATA2 SATA4 SATA3 SATA5 • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are configured, the total number of hard drives must be an even number. • A RAID 10 configuration requires four hard drives. (Note) When a RAID configuration is built across the SATA 6Gb/s channels, the system performance of the RAID configuration may vary depends on the devices are connected. Hardware Installation - 27 -