Gigabyte GA-M57SLI-S4 Manual - Page 71
To delete the array, press D in the Array Detail screen. When the Delete this array? message - sata drivers
UPC - 818313003058
View all Gigabyte GA-M57SLI-S4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
English After that, the Array List screen displaying the RAID array you created will appear (Figure 8). If you want to set the disk array as boot device, use the UP or DOWN ARROW key to select the array and press B. The Boot section will show Yes. Boot No MediaShield Utility Mar 22 2006 - Array List - Id Status Vendor Array Model Name 2 Healthy NVIDIA STRIPE 223.57G [Ctrl-X] Exit [ ] Select [B] Set Boot [N] New Array [ENTER] Detail Figure 8 To read more information about the RAID array, press ENTER to enter the Array Detail screen (Figure 9), where you should see detailed information about RAID mode, disk block size, disk model name, and disk capacity, etc. RAID Mode: Striping Striping Width : 1 MediaShield Utility Mar 22 2006 - Array Detail - Striping Block: 64K Adapt 1 1 Channel 0 1 M/S Master Master Index 0 1 Disk Model ST3120026AS ST3120026AS Capacity 111.79GB 111.79GB [R] Rebuild [D] Delete [C] Clear Disk [ENTER] Return Figure 9 To delete the array, press D in the Array Detail screen. When the "Delete this array?" message appears, press Y to confirm or N to cancel. Press ENTER to return to the Array List screen. To exit the Nvidia RAID utility, press ESC in the main menu or Ctrl+X in the Array List screen. Now, you can proceed to install the SATA controller driver and operating system. - 71 - Appendix