Gigabyte GA-Z87X-UD4H User Manual - Page 28
GSATA3 6/7 SATA 6Gb/s Connectors, Controlled by Marvell, 88SE9172 Chip, Z87 Chipset
View all Gigabyte GA-Z87X-UD4H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
8) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors, Controlled by Intel® Z87 Chipset) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel Z87® Chipset supports RAID 0, RAID 1, RAID 5, and RAID 10. Refer to Chapter 3, "Configuring SATA Hard Drive(s)," for instruc- tions on configuring a RAID array. G.QBOFM G.QBOFM G.QBOFM SATA3 Pin No. Definition 7 1 1 GND 2 TXP 7 1 3 TXN 531 4 GND 420 5 RXN 6 RXP 7 GND UG DEBUG T PORT 9) GSATA3 6/7 (SATA 6Gb/s Connectors, Controlled by Marvell® 88SE9172 Chip) The SATA connector conforms to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The Marvell® 88SE9172 chip supports RAID 0 and RAID 1. Refer to Chapter 3, "Configuring SATA Hard Drive(s)," for instructions on configuring a RAID array. G.QBOFM GSATA3 7 1 7 1 7 6 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND •• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. •• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) G •• A RAID 10 configuration requires four hard drives. Hardware Installation - 28 -