Gigabyte MD50-LS0 Manual - Page 24
SAS0/SAS1/SAS2/SAS3/SAS4/SAS5/SAS6/SAS7 SAS cable connectors
View all Gigabyte MD50-LS0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
12) SATA0/SATA1/SATA2/SATA3/SATA4/SATA5 (SATA 6Gb/s Connectors/SATA1 Support SATA DOM Function) 13) SSATA0/SSATA1/SSATA2/SSATA3 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and 1.5Gb/s standard. Each SATA connector supports a single SATA device. Please see page 34 for SATA DOM jumper setting. 7 1 SATA1 SATA0 SATA3 SATA2 Normal Mode: SATA5 SATA4 Pin No. SSATA1 SSATA0 1 SSATA3 SSATA2 2 Definition GND TXP 3 TXN 4 GND 5 RXN 6 RXP 7 GND SATA DOM Mode: Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP P5V DEBUG PORT • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are configured, the total number of hard drives must be an even number. • A RAID 10 configuration requires four hard drives. (Note) When a RAID configuration is built across the SATA 6Gb/s channels, the system performance of the RAID configuration may vary depends on the devices are connected. 14) SAS0/SAS1/SAS2/SAS3/SAS4/SAS5/SAS6/SAS7 (SAS cable connectors) The SAS connectors conform to SAS 6Gb/s standard. The SAS0/1/2/3/4/5/6/7 ports can be activated by using Gigabyte extension card. SAS4 SAS0 SAS5 SAS1 SAS6 SAS2 SAS7 SAS3 Pin No. Definition 7 1 GND 2 TXP 3 TXN 4 GND 5 RXN 1 6 RXP 7 GND Hardware Installation - 24 -