Gigabyte MNIC8CI Manual - Page 18
INV_BRIG1 Inverter With Box Header, SATA1/2 SATA 3Gb/s Connectors
View all Gigabyte MNIC8CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
9) INV_BRIG1 (Inverter With Box Header) 5 Pin No. Definition 1 12V Power 2 12V Power 3 GND 4 Backlight Controller 5 Backlight Enable 1 10/11) SATA1/2 (SATA 3Gb/s Connectors) The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. SATA2 SATA1 SATA2 SATA1 7 7 1 1 Pin No. 1 2 3 4 5 6 7 Definition GND TXP TXN GND RXN RXP GND • A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are configured, the total number of hard drives must be an even number. • A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) • A RAID 10 configuration requires four hard drives. (Note) When a RAID configuration is built across the SATA 3Gb/s channels, the system performance of the RAID configuration may vary depends on the devices are connected. Hardware Installation - 18 -