Haier EB-3190EC User Manual - Page 8

English Instruction for use Place the appliance on an even and non-skid surface. It must be stable enough to easily support the appliance even if the oven contains goods. Leave a space of at least 15 cm between the foremost edge of the worktop and the front of the oven door . You will thus prevent the appliance from tilting forward when the door is open. Install the oven in a place where it is protected against splashing water or dripping liquids. Never operate the appliance outdoors. Sunlight and humidity may impair operational safety. Never expose your microwave oven to direct sunlight (overheating hazard). Do not install the appliance in the immediate vicinity of heat sources such as radiators or cookers. When you install your oven, make sure there is adequate ventilation for your oven by leaving at least 10 cm of space behind, and 5 cm on the sides of the oven and 30 cm of space above the oven and 85 cm of the floor. 30cm above 10cm behind 85cm on the floor 5cm on the side The appliance must not be built into a cupboard. The oven must not be built in underneath a panel or a cupboard. For some models a built under - mounting set is commercially available. Please ask your dealer or the respective customer support service. CAUTION! During operation clouds of steam escape through the air vents of the appliance and it may get very hot within the space of the above mentioned minimum clearances. The microwave oven should thus be installed so that no objects sensitive to heat or moisture are located near the minimum clearances. Avoid any possible overheating of the oven caused by unintentionally covering or sealing the air vents. When in operation the base of the oven may become very hot. The worktop must thus be accordingly heat-resistant. 4 Rating plate The rating plate with technical specifications is located on the cabinet, at the rear of the oven. 5 Plugging in your appliance Your appliance must be connected to a power socket with grounded connection, which complies with the respective regulations and has been installed by authorised specialists. Before plugging the appliance into the wall socket, make sure that the voltage(V) and fuse amperage 5 English Instruction for use Set the memory 1. Press / key. 2. Press the memory button until it dispaly CP-X( X is number from 1 to 5) 3. Turn the DIAL knob until it display CP-1. 4. Turn the Cooking Control knob to the ( ) symbol, dispaly: P100 5. Turn the DIAL knob until it display P 80. 6. Press the DIAL knob. 7. Then turn the DIAL knob until it display 10:00. 8. Press the DIAL knob. 9. Then press the memory for about five seconds, release it , the menu has been set. / MEMORY C _ + +30s C _ + +30s MEMORY C _ + +30s C _ + +30s C _ + +30s You will hear one beep, the set is ok. You should set the programme orderly (CP-1,CP-2,CP-3,CP-4,CP-5). Use the memory 1.Press / key. 2.Press the MEMORY button once 3.Turn the DIAL knob, until it diisplay CP-1. 4.Press the DIAL knob. it works. When cooking has finished, the oven will beep five times and display End for ten seconds. Then The oven will be on call(display the clock),please wait for a few minutes after the ferment. Auto clean After a long time of use, your microwave oven should be cleaned regularly to prevent grease and food particles from building up, with the Auto Clean function, you can clean the oven cavity easily. in the following, we will show you how to use this feature. before you use it, be sure to take all the food or water out of the cavity except the TURNTABLE COUPLER and ROLLER RING 1.Press / key. 2.Close the door, press the Auto Clean button the oven works automatically. When cooking has finished, the oven will beep five times and display End for ten seconds. Then The oven will be on call(display the clock).never open the door at this time because the it is very hot in the oven, after about then minutes later, Always use oven gloves, you can open the door, take the accessories out, Clean the inside surfaces with a soft cloth and warm, Rinse and dry. 22