Haier HBF05EAVS HBF05E Manual - Page 8
Assembly Instructions
![]() |
UPC - 688057301426
View all Haier HBF05EAVS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
English Assembly Instructions Read carefully and understand all installation instructions before installing the beer dispenser. If after completing the process you are still unsure whether the beer dispenser has been properly installed, we recommend that you contact a qualified installer. Installing the Casters Nut Follow the steps below to install the casters. 1. Empty the inside of the cabinet completely and lay the beer dispenser down sideways. We recommend that you place a piece of Wrench cardboard or cloth underneath the cabinet to prevent dents or scratches to the cabinet. Caster 2. Insert the casters into the holes on the bottom corners of the cabinet. Tighten each caster by turning the nut clockwise with the wrench provided. 3. Once all four casters have been tightened evenly, stand the cabinet in an upright position. Installing the Beer Tap Follow the steps below to install the beer tap. 1. First, remove the cabinet plug located on the worktop. Firmly grasp the cabinet plug, twist and pull upward. Draft Arm Assembly Large Philip Head Handle Note: Store this plug in a safe place as it will be required when converting the beer Small Phillips Head dispenser into a refrigerator. Gasket 2. Place the gasket over the wing nut on the bottom of the beer tap. 3. Pass the beer tube through the gasket to the Beer duct Guard Rail wing nut base of the beer tap. pilot holes 4. Push both the wing nut and the beer duct through the hole in the worktop until the beer tap is resting on top of the cabinet. 5. Align the holes of the beer tap with the gasket and pilot holes on the worktop of cabinet. 6. Secure the beer tap to the cabinet by inserting four large Phillips-Head screws into the holes and tightening. 7
![](/manual_guide/products/haier-hbf05eavs-hbf05e-manual-78415fd/8.png)