Haier HLP141E User Manual - Page 20

Troubleshooting

Page 20 highlights

English TROUBLESHOOTING Check your problem by using the chart below (If problems occur, please pull out the plug before examining) and try the solutions for your problem. If the dryer still does not work properly, contact Haier customer service center or the nearest authorized service center. Symptom Dryer won't work Dryer won't heat Garments won't dry enough Drum won't turn (The four indicator lights of Cycle button are on at the same time) Possible Cause Possible Remedy • No power to machine? • Power plug not in the wall outlet? • Front door not properly shut? • Plug in Power Cord • Reset circuit breaker or replace fuses • Close the front door Press in the Power/ON/ OFF or Start?Pause button • Heating Temperature was not set for Timed Dry? • Is temperature indicator LED indicating "Air Dry"? • Outside venting ducting is blocked? • The exhaust filter is blocked? • Reset the 'Temp' button till the indicator light indicates 'High' or 'Low', and the LED is on • Change Temp. settings to High or Low: Air Dry works without heat • Make sure outside vent is not blocked • Remove and clean Exhaust filter • Washer didn't extract enough water? • Overloaded dryer with too many garments? • Clothes not sorted to proper cycle selection? • Make sure washer spin cycle is operating properly • Reduce the amount of garments loaded in dryer • Select the right drying cycle for normal, heavy or delicate laundry loads. • Is the front door closed? • Close front door and Press the Start/Pause button WARNING! Never Overload the dryer. Never put wet clothing washer spin cycle did not extract. If troubleshooting is not resolved, unplug unit and call customer service. 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62

19
English
TROUBLESHOOTING
Check your problem by using the chart below (If problems occur, please pull out
the plug before examining) and try the solutions for your problem. If the dryer
still does not work properly, contact Haier customer service center or the nearest
authorized service center.
Never Overload the dryer.
Never put wet clothing washer spin cycle did not extract.
If troubleshooting is not resolved, unplug unit and call customer service.
Symptom
Possible Cause
Possible Remedy
Dryer won’t work
No power to machine?
Power plug not in the wall outlet?
Front door not properly shut?
Plug in Power Cord
Reset circuit breaker or
replace fuses
Close the front door
Press in the Power/ON/
OFF or Start?Pause button
Dryer won’t heat
Heating Temperature was not
set for Timed Dry?
Is temperature indicator LED
indicating “Air Dry”?
Outside venting ducting is
blocked?
The exhaust filter is blocked?
Reset the ‘Temp’ button till
the indicator light indicates
‘High’ or ‘Low’, and the LED
is on
Change Temp. settings to
High or Low: Air Dry works
without heat
Make sure outside vent is
not blocked
Remove and clean Exhaust
filter
Garments won’t dry
enough
Washer didn’t extract enough
water?
Overloaded dryer with too
many garments?
Clothes not sorted to proper
cycle selection?
Make sure washer spin
cycle is operating properly
Reduce the amount of
garments loaded in dryer
Select the right drying cycle
for normal, heavy or delicate
laundry loads.
Drum won’t turn (The
four indicator lights
of Cycle button are
on at the same time)
Is the front door closed?
Close front door and Press
the Start/Pause button
WARNING!