Haier HLT10 Instruction Manual - Page 4
Features, General Troubleshooting, Maintenance - remote control
View all Haier HLT10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
PRECAUTIONS --TO PROLONG USE TIME, PLEASE MAKE SURE THE INTERVAL OF SWITCHING ON AND OFF IS NOT LESS THAN 5 SECONDS. --PROTECT THE POWER CORD FROM BEING WALKED ON OR PINCHED, PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT THE PRODUCT. USING OF POWER: -- DO NOT CONNECT TO POWER OVER PRESCRIPTIVE VOLTAGE, USE THE CORRECT VOLTAGE AND CURRENT MARKED ON THE PRODUCT ELECTRICAL RATINGS LABEL. ELECTRIC POWER OVERLOAD WILL CAUSE FIRE OR ELECTRIC SHOCK. -- DO NOT PULL CABLES ,SHOULD HOLD PLUG WHEN USING POWER SOCKET. -- UNPLUG AC CABLE FROM POWER SOCKET IF NOT USE THE UNIT FOR LONG TIME. BATTERY USAGE AND HANDING: --KEEP BATTERY AWAY FROM CHILDREN AND PETS. --REMOVE THE BATTERY FROM THE REMOTE CONTROL WHEN THE PRODUCT WILL NOT BE USED FOR AN EXTENDED PERIOD. --NEVER THROW BATTERY INTO A FIRE. DO NOT EXPOSE BATTERY TO FIRE OR OTHER HEAT SOURCES. FEATURES 10.2″TFT DISPLAY Built in ATSC/NTSC Tuner. AUTO TV SCANNING FUNCTION MEMORY FUNCTION SUPPORT VIDEO/AUDIO INPUT DIGITAL BROADCASTING RECEPTION GENERAL TROUBLESHOOTING Check the following points before assuming malfunctions of the TV set: Problem No picture & sound No picture No sound Poor reception Dark or blurred picture Unclear or unstable picture Picture moves up & down,blurs or folds over Interfered snow picture No color Reasons Improper connection of AC adaptor or the battery power is low. Reception may not be adequate. Relate the unit or change the antenna direction. Volume is too low; Mute function is switched on. The headphone has been plugged in or the signal is too weak . TV antenna is not correctly adjusted or TV channel is not right. The bright & contrast is too low. The battery voltage is too low. TV antenna is not properly adjusted or in too weak signal reception area. TV antenna is not rightly adjusted. The signal reception is too weak or caused by signal reflection from the buildings nearby or mountains. The signal is interfered by car,s engine, railway, high tension wires, neon signs or radio frequency. Color or color system is not set properly. MAINTENANCE • Be sure to press POWER to set the player to the standby mode and disconnect the AC adaptor before maintaining the player. • Wipe the player with a dry, soft cloth. • If the surfaces are extremely dirty ,wipe clean with a cloth which has been dipped in a weak soap-and-water solution and wrung out thoroughly, and then wipe again with a dry cloth. • Never use alcohol, benzine, thinner, cleaning fluid or other chemicals. And do not use compressed air to remove dust. 2 23