Haier HSU-09H03 User Manual - Page 3

Operation Loading of the battery 1 Remove the battery cover; 2 Load the batteries as illustrated. 2 R-03 batteries,resetting key(cylinder); Be sure that the loading is in line with the " + "/"-"; 3 Load the battery,then put on the cover again. Clock set AM PM SMART 1 Press CLOCK button, "AM" or "PM" flashes. 2 Press "+" or "-" to set correct time. Each press will increase or decrease 1min. If the button is kept pressed,time will change quickly. 3 Confirm time. After time setting is confirmed, press CONFIRM,"AM "and "PM" stop flashing,while clock starts working. Note: The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well. When electronic-started type fluorescent lamp or change-over wireless telephone is installed in the type fluorescent lamp or room, the receiver is apt to be disturbed in receivingthe signals, so the distance to the indoor unit should be shorter. Full display or unclear display during operation indicates the batteries have been used up.Please change batteries. If the remote controller can't run normally during operation, please remove the batteries and reload several minutes later. Hint: Remove the batteries in case unit won't be in usage for a long period. If there are any display after taking-out, just need to press reset key SMATR Operation One key can give you a comfortable room! The air conditioning unit can judge the SMART indoor temperature and humidity, and make the adjustment accordingly. SMART SMART start Press ON/OFF button, unit starts. Press SMART button" SMART " is displayed on the remote controller and " " is displayed on AM the display board,unit will run in SMART mode. SMART ● SMART FRESH ● SMART Defrost ● SMART FAN SPEED ● SMART FAN HEALTH ● SMART DRY ● SMART SOFT ● SMART Control temperature SMART or SMART stops Under the cooling, heating and dehumidifying mode, press the smart key to enter the smart function. Under the smart running mode, when the air conditioning is running, it will automatically select cooling, heating, dehumidifying or blowing mode as per the setting temperature. When the smart function is running, press the "cooling" "heating" or "dehumidifying" key to switch to the other mode, you will exit from the smart function. COOL,HEAT and DRY Operation 1 Unit start. 2 Select operation mode. AM SMART Press COOL button" " is displayed on the remote controller and " " is displayed on the display board,unit will run in COOL mode. Press HEAT button" " is displayed on the remote controller and " " is displayed on the display board,unit will run in HEAT mode. Press DRY button" " is displayed on the remote controller and " " is displayed on the display board,unit will run in DRY mode. 1.In DRY mode, when room temperature becomes lower than temp.setting+2oC, unit will run intermittently at LOW speed regardless of FAN setting. 2. Remote controller can memorize each operation status. When starting it next time, just press ON/OFF button and unit will run in previous status. 3. Cooling only unit do not have displays and functions related with heating. 2