Haier HSU-09H03 User Manual - Page 4

Operation Operation 1 Press TEMP button. Every time the button is pressed, temp. setting increases 0.5oC. Every time the button is pressed, temp. setting decreases 0.5oC. HEALTH Operation The anion generator in the airconditioner can generate a lot of anion effectively balance the quantity of position and anion in the air and also to kill bacteria and speed up the dust sediment in the room and finally clean the air in the room. AM SMART Unit will start running to reach the temp. setting on LCD. 2 Press FAN SPEED button. For each press, fan speed changes as follows: LOW MED HI AUTO Unit will run at selected fan speed. AM SMART Operation 1 For each press of " "button, air flow direction on remote controller displays as follows according to different operation modes: COOL/DRY: HEAT: SMART: Initial state 2 For each press of " "button, remote controller displays as follows : remote controller: Initial state AM SMART Press HEALTH button For each press, is displayedAir conditioner starts health anion function operation. Press HEALTH button For twice press, disappears,the operation stops. When indoor fan motor is running, it has healthy process function. (It's available under any mode) When the fan in the indoor unit does not work, the health lamp lights up,but the anion generator does not release anion. HEALTH AIRFLOW Operation The setting of health airflow function 1).Press the button of health airflow, appears on the display. Avoid the strong airflow blows direct to the body. 2).Press the button of health airflow again, appears on the display. Avoid the strong airflow blows direct to the body. AM SMART The cancel of the health airflow function Press the button of health airflow again, both the inlet and outlet grills of the air conditioner are opened, and the unit goes on working under the condition before the setting of health airflow function. After stopping, the outlet grille will close automatically. Notice: Cannot pull direct the outlet grille by hand. Otherwise,the grille will run incorrectly. If the grille is not run correctly,stop for a minute and then start, adjusting by remote controller. Remote controller can memorize each operation status. When starting it next time,just press ON/OFF button and unit will run in previous status. When humidity is high,condensate water might occur at air outlet if all vertical louvers are adjusted to left or right. It is advisable not to keep horizontal flap at downward position for a long time in COOLor DRY mode ,otherwise, condensate water might occur. As cold air flows downward in COOL mode, adjusting air flow horizontally will be much more helpful for a better air circulation. 3 Note: 1 .After setting the health airflow function, the position of inlet and outlet grills is fixed. 2.In heating, it is better to select the mode. 3.In cooling, it is better to select the mode. 4.In cooling and dry, using the air conditioner for a long time under the high air humidity, a phenomenon falling drips of water occurs at the outlet grille . 5.Select the appropriate fan direction according to the actual conditions.