Haier HWD120-B1558 User Manual - Page 34

9- Troubleshooting GB 9-3 Troubleshooting without display code Problem Cause Solution Appliance fails to operate. Control panel is out of function • Programme is not yet started. •
Door is not properly closed. • Appliance has not been switched on • Power failure. •
Child lock is activated •
Time delay is activated? •
Pause button is pressed? • Child lock is activated? •
Check programme and start it. •
Close the door properly. •
Switch the appliance on. • Check power supply. •
Deactivate child lock. •
Deactivate time delay function. •
Deactivate pause modus. •
Deactivate child lock. with water. Appliance is draining Drainage failure Strong vibration while spinning. Operation stops before completing wash cycle. •
No water. •
Inlet hose is kinked. •
•
Water pressure is too low. •
Door is not properly closed. •
Water supply failure. •
Time delay is activated? •
Start button in not touched? •
Check water tap. •
Check inlet hose. •
•
Check water pressure. •
Close the door properly. •
Ensure the water supply •
Deactivate time delay function. •
Touch start button. • Height of drain hose is below 80 •
Make sure that drain hose is cm. properly installed. •
Drain hose end could reach into water. • Make sure the drain hose is not in water. • Drain hose is blocked. •
Unblock drain hose. • •
• Drain hose end is higher than 100 •
Make sure that drain hose is cm above floor level. properly installed. •
Not all transportation bolts have •
Remove all transportation been removed. bolts. •
Appliance has no solid position.
•
Ensure solid ground and a ev- elled position. •
Machine load is not correct. •
Check load weight and balance.. •
Water or electric failure. • Pause button is pressed? •
Check power and water supply. •
Deactivate pause modus. Operation stops for a period of time. • Appliance displays error informa- •
Consider display information.
tion. • Problem due to load pattern. •
Reduce or adjust load. •
Programme performs soaking cycle? •
Cancel programme and restart. Excessive foam floats • Detergent is not a appropriate
drum and/or deter- gent drawer. •
Excessive use of detergent. •
Check detergent recommen- dations. •
Reduce amount of detergent. Automatic adjustment • Washing programme duration will be •
This is normal and doesn't af- of washing time. adjusted. fect functionality Spinning fails. •
Unbalance of laundry. •
Check machine load and laun- dry and run a spinning programme again
 34