Haier HWD120-B1558 User Manual - Page 37

GB 10- Installation 10.1 Preparation
Take the appliance out of the packaging.
Remove all packaging material including the poly- styrene base (A) with part (B) (Fig. 10.1) and the of childrens reach. While opening the package, water drops may be seen on plastic bag and porthole. This normal phenomenon results from water tests in the factory. 10.1 # " Note: Packaging diposal Keep all packaging materials out of childrens reach and dispose them in an environmentally friendly manner. 10.2 Dismantle the transportation bolts and packaging screws The transportation bolts are designed for clamping anti-vibration components inside the appliance during transportation to prevent inner damage. 1.
Remove the 2 packaging screws (A) on the rear side and take out plastic spacers (C) from inner side of the machine. (Fig. 10.2-1. and 10.2-2.) 2.
Remove the 5 transportation bolts (B) and take out plastic spacers (D) from inner side of the appliance (Fig. 10.2-3.). 3.
Fill left holes with blanking plugs (E) (Fig. 10.2-4.). 10.2-1 B  A B Note: Keep in safe place Keep the transportation bolts in a safe place for later - install the bolts. Moving the appliance If the machine is to be moved to a distant location, replace the transportation bolts removed before installation to prevent damage: 1.
Remove the blanking plugs. 2.
Insert the plastic spacers and the transportation bolts as well as the packaging screws. 3.
Tighten the bolts with a spanner. 10.2-3 $ 10.2-2 " 10.2-4 & 37