Haier HWM120-1678ES5 User Manual - Page 9
Connection between the water inlet hose jointer and the water faucet, Connection between the water
View all Haier HWM120-1678ES5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation & Adjustment Connection between the water inlet hose jointer and the water faucet 1.Press the lower end of the locking lever and push down the slider. Remove the water inlet hose jointer from the water inlet hose component. See Figure 1. 2.Remove the nameplate. Make sure the * is 4mm above the screw nut. See Figure 6. If the * is less than 4mm above the screw nut. Loosen the screws. Locking Lever Water inlet hose Water inlet hose jointer Slider Philips screw driver Screw Nameplate Bushing Figure 1 Figure 2 Figure 3 3.Insert the jointer of the water inlet hose on the faucet. See Figure 2.If the faucet is too large and the jointer cannot be inserted on the water faucet, please loosen the four screws and remove the bushing in the jointer. The front end of the faucet must be smooth, otherwise it may leak water. See Figure 3. 4.Tighten the four screws evenly. See Figure 4. 5.Turn the screw nut in the arrow direction, see Figure 5. After installation, the * is less than 2mm above the screw nut. See Figure 6. Figure 4 Screw nut Figure 5 * About 4mm before twisting About less than 2mm after twisting Figure 6 Connection between the water inlet hose and the washer 1.Do not remove the water absorption cushion. nut of the water inlet hose Please check if the cushion is dropped or damaged before use. If it happens please contact our after-sale department immediately. 2.Put the nut of the water inlet hose on the valve jointer. water absorption cushion 3.Tighten the nut. Swing the hose gently to ensure its jointer of the water inlet valve firmly connected. 7