Haier HWM60-M1201 User Manual - Page 8
Installation of water inlet hoses
View all Haier HWM60-M1201 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installation of water inlet hoses The new hose-sets supplied with the appliance are to be used and that old hose-sets should not be reused water faucet,suitable The exit end face of the faucet water faucet, not suitable It is required that the front end shall be longer than 10mm. The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage. Connection between the water inlet hose jointer and the water faucet 1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1. 2.Take off the nameplate. Make sure the threading is 4mm above the upper surface of the nut. See to Figure 6. If the threading is less than 4mm above the upper surface of the nut. please loosen the screws. Lock level Water inlet hose jointer Slider Screw knife Screw Nameplate Bushing Figure 1 Figure 2 Figure 3 3.Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. See to Figure 2.(If the faucet is too large and the jointer can not be set on the water faucet, please loosen the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth, otherwise it may leak water. See to Figure 3.) 4.Fasten the four screws evenly. See to Figure 4. 5.Twist the fastening nut, See to Figure 5. After installation, the threading is less than 2mm above the upper surface of the nut. See to Figure 6. Figure 4 Screw nut Figure 5 About 4mm before twisting About less than 2mm after twisting Figure 6 1.Do not take off the water absorption cushion. Please check if the cushion is dropped or damaged before each usage. If it happens please contact our after-sale department immediately. 2. Put the nut of the water inlet hose on the valve jointer. 3. Fasten the nut. Swing it gently to confirm if itČs suitable. jointer of the water inlet valve nut of the water inlet hose water absorption cushion Connection between the jointer of the water inlet hose and the water inlet hose 1.Push down the slider. Insert the water inlet hose into the jointer. 2.Hang the lock lever to the jointer. Release the slider till a click sound is heard. Locking level the jointer of the water inlet hose Slider Check the connection between the jointer of the water inlet hose and the water faucet 1.Swing the hose gently to confirm if it is fastened stable. 2.After installation, open the faucet to check if it leaks. 3.Do not bend the hose with overstrain. 4.Before each usage please check if the connection between the jointer of the water inlet hose and the water faucet, and the installation of the water inlet hose are firm, so as to prevent dropping from improper installation position. Dismantle the water inlet hose 1.Close the water faucet. 2.Press the locking lever. Push down the slider.Then pull off the water inlet hose.If the machine is used frequently, the jointer of the water inlet hose can be kept on the faucet to prevent damaging the fixing screw. Locking level Slider