Haier HWM65TLF User Manual - Page 18

Leveling Your Washer Your washer has 2 leveling legs; which are located on the bottom corners. After properly placing your washer in its final position, you canlevel your washer. Leveling legs can be adjusted by turning them counter clockwise to raise your washer or turning them clockwise to lower your • washer. Adjustable foot High Low Steps for Installation Select a away suitable location for the washer on a hard even surface from direct sunlight or heat source e.g. radiators, base board heaters, cooking appliances etc.Any floor unevenness should be corrected with the leveling legs located on the bottom corners of the washer.The washer must be placed at room temperature.You must not place washer where the temperature is at below freezing. Installing Your W a sher: Read through these instructions carefully before installation. 1.Insert a new flat washer into each end of the water inlet hoses. Firmly put the washers in the coupling. 2. Connect the hot and cold water inlet hoses to the hot and cold water faucet. 3. Connect the other end to the corresponding washer inlet located at the back of machine. Note: You may have to use pliers to tighten the coupling. Do not over tighten because you may cause damage to the valve. You should use the new hose-sets supplied with the washer. Old hose-sets should not be reused. 4.install the drain hose to the side of the washer using the drain hose damp provided. The drain hose must be placed into a drainpipe or sink at least 1 1/2inches in diameter. Use the gooseneck to the hose in place. To avoid possible water back up, the drain hose must reach a minimum height of 900mm and a maximum height of 1200mm. 17