Haier HWM80-000S Operation Manual - Page 10

Using Process Disposal after washing After using, please clean the lint and foreign materials of the lint filter and lint frame in time. Otherwise it may influence your using the machine. Please first pull the power plug from the receptacle before cleaning. Cleaning the lint filter The lint filter must be used during washing. It must be cleaned in time after each using. -1 1. Take off the lint filter Put hand at the indicated position. Push down to take it off. (See to Figure 1) 2. Clean the lint -2 Put it in water and clean while it is still wet. (See to Figure 2) 3. Install the lint filter After cleaning, insert the bottom of -3 the lint after filter (marked with "DOWN SIDE") into the filter frame, then push the upper part of the filter in (marked with "UP SIDE").(See Figure 3) Figure 1 Figure 2 15 Figure 3 Using Process Disposal after washing Cleaning the frame filter Too much lint on the overflow filter will influence the normal usage of the machine. Please clean it every two months. 1. Take off the overflow filter As indicated in the figure, nip the elastic fixing claw and pull it to the direction of the arrow to take it off. 2. Take off the corrugation pipe. Dismantle the upper inside the overflow filter (as indicated in Figure1). 3. Clean the overflow filter Clean the lint around the filter and flush with tap water. 4. Install the overflow filter (1) Install the corrugation pipe. (2) Insert the mounting plate at the bottom of the filter into original position. (3) Hang up the hook at the left upper side. (4) Push the upper part in as indicated in Figure2.) Water level adjusting lever Pipe Figure 1 Elastic fixing claw Hook Figure 2 -1 -2 -3 -4 (4) 16