Haier HWM80-000S Operation Manual - Page 11

Using Process Disposal after washing Disposal of the complete unit 1. After washing, dismount the water -1 inlet hose. 2. Do not store water in the tub for long -2 period. Discharge the water immediately after each using. 3. Pull of the power plug and hang up -3 the power cord. 4. Hang up the drain hose. -4 5. Wipe off the water drops on the surface and inside the tub with clean -5 soft cloth. 6. Open the cover of the wash for some time (about one hour), then -6 close them. 7. Wipe the complete unit with soft -7 cloth twisted dry. 8. Wipe with neutral detergent if too -8 dirty. 9. Do not wash it directly by water. -9 10. Do no wipe with thinner, petrol, alcohol, etc. -10 Petrol Thinner Alcohol 17 Using Process Trouble-shooting (Answers to questions) When the remained water is frozen Prevent the freezing (Be sure to discharge the water completely after using) After complete draining, set the "WASH SELECTOR" at "SOFT" or "STANDARD". If it is set an "DRAIN", it will be rather difficult for the frozen water to melt. When the water is frozen Pour hot water below 50OC into the wash to soak it completely, Then turn the pulsator with hands gently. Please confirm the can work normally before next using. O Below 50 C 2-3L If the laundries fall to the out side of the spin tub If the laundries fal to the outer side of the spin tub, please take them out immediately. 1. Dismantle As indicated in the figure, push the point marked with to pull the spin tub frame to oblique upwards to dismantle it. 2. Install After install the back edge of the spin tub frame to proper position, push the four points marked with " " by force to reset it. Spin tub frame Please check carefully. The laundries may fall to the lower part of the outer side of the spin tub (as indicated in the figure.) If the laundries fall to the outer side of the spin tub, during spinning the draining will get blocked and the rotation speed of the spin tub is reduced. Spin tub Laundries 18