Haier HWM80-316S6 HWM80 90 100 120-316S6 User Manual - Page 9
Connection between the water inlet hose jointer and the water faucet, Connection between the water
View all Haier HWM80-316S6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation and adjustment Connection between the water inlet hose jointer and the water faucet 1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1. 2.Take off the nameplate. Make sure the threading is 4mm above the upper surface of the nut. See to Figure 6. If the threading is less than 4mm above the upper surface of the nut. please loosen the screws. Lock lever Water inlet hose Water inlet hose jointer Slider Screw driver Screw Nameplate Bushing Figure 1 Figure 2 Figure 3 3.Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. See to Figure 2.(If the faucet is too large and the jointer can not be set on the water faucet,please loosen the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth, otherwise it may leak water. See to Figure 3.) 4.Fasten the four screws evenly. See to Figure 4. 5.Twist the fastening nut, See to Figure 5. After installation, the threading is less than 2mm above the upper surface of the nut. See to Figure 6. Figure 4 Screw nut Figure 5 Figure 6 About 4mm before twisting About less than 2mm after twisting Connection between the water inlet hose and the washer 1.Do not take off the water absorption cushion. Please check if the cushion is dropped or nut of the water inlet hose damaged before each usage.If it happens please contact our after-sale department immediately. 2.Put the nut of the water inlet hose on the valve jointer. water absorption cushion jointer of the water inlet valve 3.Fasten the nut. Swing it gently to confirm if it's suitable. 7