Haier QDP555SBNTS Installation Instructions - Page 13

Dishwasher Installation STEP 18 CONNECT POWER SUPPLY If a power cord with plug is already installed proceed to Step 19. WARNING If house wiring is not 2-wire with ground, a ground must be provided by the installer. When house wiring is aluminum, be sure to use UL-Listed anti-oxidant compound and aluminum-to-copper connectors. In this step you will need the junction box cover and the #10 Hex head screw from the screws set aside in Step 1. • Secure house wiring to the back of the junction box with a strain relief. • Locate the 3 dishwasher wires, (white, black and green) with the stripped ends coming out of the AC jumper. Use UL listed wire nuts of appropriate size to connect incoming ground to green, white to white and black to black. • Install the junction box cover using #10 hex head screw. Check to be sure that wires are not pinched under the cover. • Make sure that the junction box cover is resting on the mounting bracket. • If using a Power Cord Kit, use GE Appliances part number WX09X70910 or WX09X70911 and refer to the included instructions. NOTE: Do not remove the Junction Box Bracket. White Ground (Green) AC Jumper STEP 19 PRETEST CHECKLIST Review this list after installing your dishwasher to avoid charges for a service call that is not covered by your warranty. • Check to be sure power is OFF. • Open door and remove all foam and paper packaging. • Locate the Owner's Manual set aside in Step 1. • Read the Owner's Manual for operating instructions. • Check door opening and closing. If door does not open and close freely, check for proper routing of spring cable over pulley. If door drops or closes when released, adjust spring tension. See Step 2. • Check to be sure that wiring is secure under the dishwasher, not pinched or in contact with door springs or other components. See Step 18. • Check door alignment with tub. If door hits tub, level dishwasher. See Step 14. • Check door alignment with cabinet. If door hits cabinet, reposition dishwasher. See Step 13. • Check that door spring does not contact water line, fill hose, wiring or other components. See Step 13. • Verify water supply and drain lines are not kinked or in contact with other components. Contact with motor or dishwasher frame could cause noise. • Turn on the sink hot water faucet and verify water temperature. Incoming water temperature must be between 120°F and 140°F. A minimum of 120°F temperature is required for best wash performance. See "Prepare Hot Water Line," page 5. • Add 1 quart of water to the bottom of the dishwasher to lubricate the pump seal. • Turn on water supply. Check for leaks. Tighten connections if needed. • Remove protective film if present from the control panel and door. • Check that tub trim does not contact the door. Black Ground Screws Junction Box Bracket Figure AD NOTE: All ground screws, brackets and wires must remain intact. 13