Haier QDP555SBNTS Installation Instructions - Page 7
Install Drain Hose
View all Haier QDP555SBNTS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Dishwasher Installation STEP 4 REMOVE TOEKICK • Remove the 2 toekick screws and toekick. Set aside for use in Step 22. Toekick Remove 2 Toekick Screws STEP 8 POSITION WATER LINE AND HOUSE WIRING • Position water supply line and house wiring on the floor of the opening to avoid interference with base of dishwasher and components under dishwasher. STEP 5 FLOOR PROTECT PAN (On some models) • Pan should not be removed during installation. 4" 4" 6" 6" Water House Line Wiring Figure O Do not remove pan STEP 6 INSTALL 90° ELBOW • Thread 90° elbow Front of dishwasher onto the water valve. Ensure rubber gasket is located between valve and elbow. Water Valve Bracket • Do not overtighten elbow. Water valve bracket could bend or water valve fitting could break. • Position the end of the elbow to 90° Elbow face the rear of the Fill Hose dishwasher. Figure M STEP 7 INSTALL DRAIN HOSE TO DRAIN LOOP Connect drain loop end to drain hose using the clamp as shown in the figure. NOTE: The high drain loop on the side of the tub is designed for better wash performance. Do not remove from the side of the tub. STEP 9 INSTALL DRAIN HOSE, THROUGH CABINET • Position dishwasher in front of cabinet opening, and if present, dislodge drain hose from drain hose clip. Insert drain hose into the hole in cabinet side. If a power cord is used, guide the end through a separate cabinet opening. Pull insulation blanket over collar House Wiring Power Cord (If used) Water Line Drain Hose Ensure drain hose is not twisted or pinched Insulation Blanket Maximum drain hose length is 15' Do not disconnect or remove high drain loop from left side of dishwasher Figure P Tip: Prevent unnecessary service call charges for fill, drain or noise concerns. Position utility lines so they do not interfere with anything under or behind the dishwasher. 7