Haier QNE27JYMFS Use and Care Manual - Page 17
Plug In The Refrigerator, Put The Refrigerator In Place, Level The Refrigerator, Level
View all Haier QNE27JYMFS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
INSTALLATION INSTRUCTIONS CONNECTING TO THE HOUSE WATER LINE A cold water supply is required for automatic icemaker operation. If there is not a cold water supply, you will need to provide one. See Installing the Water Line section. NOTES: • Before making the connection to the refrigerator, be sure the refrigerator power cord is not plugged into the wall outlet recommend installing one if your water supply has sand or particles that could clog the screen of the refrigerator's water valve. Install it in the water line near the refrigerator. If using SmartConnect™ Refrigerator Tubing Kit, you will need Before connecting the water line to the house, purge the house line for at least 2 minutes. A. If you are using copper tubing, place a compression nut and ferrule (sleeve) onto the end of the tubing coming from the house cold water supply. If you are using the SmartConnect™ tubing, the nuts are already assembled to the tubing. B. If you are using copper tubing, insert the end of the tubing into the refrigerator connection, at the back of the refrigerator, as far as possible. While holding the tubing If you are using SmartConnect™ tubing, insert the molded end of the tubing into the refrigerator connection, at the back of the refrigerator, and tighten the compression nut until it is hand tight. Then tighten one additional turn with a wrench. Over tightening may cause leaks. WARNING Connect to potable water supply only. A cold water supply is required for automatic icemaker operation. The water pressure must be between 40 and 120 psi (275-827 kilopascals). WARNING ELECTRIC SHOCK HAZARD Attach tubing clamp using existing hole only. DO NOT drill into the refrigerator. SmartConnect™ tubing house water supply) and check for any leaks. PLUG IN THE REFRIGERATOR On models with an icemaker, before plugging in the refrigerator, make sure the position. See the grounding information attached to the power cord. PUT THE REFRIGERATOR IN PLACE LEVEL THE REFRIGERATOR Adjustable legs at the front corners of the refrigerator should be set so just enough that the door closes easily when opened about halfway. To adjust the leveling legs, turn the legs clockwise to raise the refrigerator, counterclockwise to lower it. LEVEL THE REFRIGERATOR DOORS Remember a level refrigerator is necessary for getting the doors perfectly even. If you need help, review the previous section on leveling the refrigerator. If the doors remain uneven, turn the adjustable pin to raise the lowest door using a 1/4" allen wrench to turn the pin. When the left door is lower than the right door. When the left door is higher than the right door. Refrigerator connection 49-60806 Rev. 1 ENGLISH Adjustment point 17