Haier SC-310 User Manual - Page 7
EMS-55 Operation and function, Instruction
View all Haier SC-310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
EMS-55 Operation and function Operation and function Display temperature in the refrigerator Press the 2nd button at the right side on panel ('up' key), current temperature will be shown on the display for about 5 seconds, and then it will return to the original status automatically. It is available for this operation under both operation mode and non-operation mode and it can also be conducted several times. Description above is applicable to the E43 edition. For E46 edition, you can watch temperature on the panel. If you want to check temperature setting, press"SET" button(the first one from the left side ) EMS will display both the letters "SP"intermittently (Setting point) and the pre-selected temperature settings Pick-up sales/performance statistic data When pressed 2 buttons at middle at one time, EMS will display the following character s and statistic values H1 the highest record temperature L0 the lowest record temperature AT average temperature DC door opening counts CNT pedestrians flow counts CC compressor (on/off) counts CH compressor operation hours Af pedestrians flow density setting Activate an extra defrosting If you want to activate an extra defrosting, press the"defrost" button at the right side. Distinguish EMS normal operation status After plugging in, compressor runs firstly, about 20 seconds later air fan starts to work. When the door is open, the interior air fan stops running(in a status that temperature drops down continuously, interior air fan is not controlled by open/close door) . Under the non-operation mode, interior air fan and compressor work and stop alternatively. System performs self-defrost every 6 hours. The whole process of defrosting lasts around l5 minutes and the compressor stops while interior air fan still works. Operation mode, light is on; non-operation mode, off(delayed) When door is open for 2 min, it will buzz; when it is open for more than 5min, power will be cut off until door is closed. 13 Instruction Ambient environment This product should be placed on flat and solid ground, with pallet package removed so as to reduce vibration and noise. Tilting angle should not be more than 45 when transportation or moving. This product should be placed far from direct sunlight and heat source and the surrounding temperature should not be above 43 C. To ensure normal refrigeration effect and easy ventilation and heat dissipation, there should be enough room left around. Bumper bar should be installed at the back side and there should be at least 5cm between the back side and wall. Do not place it in environmentwhere it is too cold Far from the humid place or where water is easily splashed. The splashed water and attains should be cleaned by soft cloth in time to prevent the product from getting rusty or affect the insulating property. Do not place furniture or articles with sharp edges near the freezer in order to avoid possible collision while opening the glass door. 6