Haier UVH13012MSS Use and Care Manual - Page 18

INSTALLATION INSTRUCTIONS Installation Instructions A. OUTSIDE TOP EXHAUST (Vertical Duct) INSTALLATION OVERVIEW A1. Attach Mounting Plate to Wall A2. Prepare Top Cabinet A3. Adjust Blower Exhaust A4. Install Exhaust Adaptor A5. Mount the Kitchen Hub™ A6. Connect Ductwork A7. Finalize Installation A1 ATTACH THE MOUNTING PLATE TO THE WALL A B C D Attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud. Recommended locations on the mounting plate are indicated by A, B, C and D. 1. Remove the toggle wings from the bolts. 2. Insert the bolts into the mounting plate through the holes designated to go into drywall and UHDWWDFKWKHWRJJOHZLQJVWR»ƎRQWRHDFKEROW To use toggle bolts: Spacing for Toggles More Than Wall Thickness Mounting Plate Toggle Wings Toggle Bolt A1 ATTACH THE MOUNTING PLATE TO THE WALL (Cont.) CAUTION Be careful to avoid pinching fingers between the back of the mounting plate and the wall. 4. Tighten all bolts. Pull the plate away from the wall to help tighten the bolts. A2 USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor. Wall Mounting Plate Bolt End 3. Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. NOTE: Before tightening toggle bolts and wood screw, make sure the tabs on the mounting plate touch the bottom of the cabinet when pushed flush against the wall and that the plate is properly centered under the cabinet. 18 Ŷ5HDGWKHLQVWUXFWLRQVRQWKH723&$%,1(7 TEMPLATE. Ŷ7DSHLWXQGHUQHDWKWKHWRSFDELQHW Ŷ'ULOOWKHKROHVIROORZLQJWKHLQVWUXFWLRQVRQWKH TOP CABINET TEMPLATE. CAUTION Wear safety goggles when drilling holes in the cabinet bottom. 49-2000492 Rev. 2