Haier UVH13012MSS Use and Care Manual - Page 7
CARE AND CLEANING, Filters
View all Haier UVH13012MSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
CARE AND CLEANING: Filters Filters Be sure the circuit breaker is off and all surfaces are cool before cleaning or servicing any interior part of the unit. Metal Grease Filter The metal filters trap grease during cooking. The filters must ALWAYS be in place when the unit is in use. The grease filters are dishwasher-safe and should be cleaned every month, depending on the usage of the unit. To remove: Press on the filter handle to disengage the filter lock to release the filter. To replace: Fit the tabs at the bottom of the filter into the slots in the back of the filter opening. Lift up the front side of the filter and push gently until the filter locks into place. Make sure the filter lock is in the closed position to secure the filter. To clean: Swish the filter in hot soapy water and rinse in clean water or wash it in the dishwasher. Do not use abrasive cleansers. Metal Grease Filter NOTE: Some discoloration of the filter may occur in the dishwasher. Charcoal Filter (for recirculation installation only) If the model is not vented to the outside, the air needs to be recirculated through a disposable charcoal filter that helps remove smoke and odors. NOTE: DO NOT rinse, or put charcoal filter in an automatic dishwasher. To remove: 1. Remove the metal filters-see Metal grease filter section. 2. Remove the charcoal filter on each side of the blower. The charcoal filters are included with the unit. They cannot be cleaned. It is recommended that the charcoal filter be replaced every 6 months or if it is noticeably dirty or discolored. Order Charcoal Filter UXCF91 To inquire about purchasing replacement charcoal filters or to find the location of a dealer nearest you, please call our toll-free number: Charcoal Filter Mount National Parts Center 800.626.2002 (In Canada: 800.661.1616) To install: 1. Remove the metal filters-see Metal Grease Filter section. 2. Install the charcoal filter mounts to either side of the motor. 3. Insert the snap on the charcoal filter into the center on the mount. 4. Clip the charcoal filter in until it is locked. 5. Repeat with second filter on the other side of the motor. 6. Replace the metal filters - See Metal Grease Filter section. 49-2000492 Rev. 2 7