Hamilton Beach 40715 Use & Care - Page 4

840181701 ENnv01.qxd:Layout 1 6/17/09 11:34 AM Page 4 Before First Use Wash all removable parts in warm, soapy water. No parts may be washed in a dishwasher. (Priming the Pump) The water pump must be "primed" before first use to work properly. Operating without water in the reservoir can permanently damage the appliance. 1 Make sure all three buttons are in the OFF position (not pushed in) and that the steam control dial is turned fully clockwise to NO STEAM . 2 Fill the removable water reservoir to the MAX fill line with cold water and replace securely on the back of unit. 3 Plug in the unit and press ON/OFF button to turn unit on. 4 When unit is ready, the light next to the temperature control button will glow green. Place an empty container under frothing nozzle so that nozzle is completely inside container. 5 Turn the steam control dial counterclockwise to STEAM . Press pump button to pump hot water out of frothing wand for cleaning purposes. 4 6 Fill the container about halfway full. NOTE: The green light next to temperature selection button will turn off once pump button is pushed. 7 Press pump button again to turn frothing nozzle off; then turn steam control dial clockwise to NO STEAM . 8 Place a container under brew head-it should be wide enough to catch water from both spouts. Press pump button and dispense any remaining water from reservoir.