Hamilton Beach HMD400 User Guide - Page 7
Motor Replacement, Technical Service - commercial drink mixer
UPC - 040094911028
View all Hamilton Beach HMD400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Care and Cleaning of the Mixer Motor Replacement Single Spindle Drink Mixer shown for illustration purposes. Please follow the same procedure for Triple Spindle Drink Mixer. wWARNING Electrical Shock Hazard Disconnect power before servicing. Replace all parts before operating. Failure to do so can result in death or electrical shock. Technical Service For assistance or replacement parts, call our Technical Service number: 866-285-1087 or 910-693-4277 8:00 a.m. - 5:00 p.m. EST Monday - Friday www.commercial.hamiltonbeach.com To replace the motor, follow the steps below, or call an authorized service center. 1. Unplug mixer. 2. Loosen the three screws in the top cover (the screws will remain in the cover). Lift off the top cover and rest against the rear panel of the mixer. 3. Squeeze the tabs on the sides of the connector plug and pull the two plug halves apart. 4. Lift the motor/ agitator assembly straight up and out of the housing. Discard the motor assembly in an environmentally acceptable manner that complies with Federal, State and local waste management regulations. 5. Carefully lower the new motor/agitator assembly into the housing, guiding the spindle through the hole in the housing. Align the rounded indent on the front of the rubber support with the front screw boss in the housing. 6. Plug the two halves of the plug connector together, ensuring that all lead wire colors match, and tuck the connector into the back of the housing. Make sure that the side clips on the plug halves engage. NOTE: The plug will only connect together in one way. 7. Make sure that all wires are out of the way and that they cannot come in contact with the motor. Then lower the cover into place, making sure that the upper tab and seal of the back panel are in place below the lip of the cover. Secure the cover with the screws. 8. Plug mixer into a grounded outlet. 7