Harbor Freight Tools 62337 User Manual - Page 15

OPERATION CONNECTING THE POWER CORD (See Fig.6) 1. Secure the extension cord to the motor housing using the notch at rear of blower. This prevents accidental removal of the electrical cord. 2. Plug the female end of the electrical cord into the receptacle at the back of the unit. Fig. 6 STARTING/STOPPING THE BLOWER/ MULCHER (See Fig.7) This unit is equipped with a three-way (Off/ LOW/ HIGH) switch • Slide the switch forward to the first position for LOW speeds up to 150 MPH (241Kph). • Slide the switch forward to the second position for HIGH speeds up to 230 MPH (370Kph). Once the unit is plugged in, stand in the operating position. Slide the power/speed switch to LOW or HIGH to start the unit. To stop the unit, slide the switch to Off. Fig. 7 ON OFF HOLDING THE BLOWER/MULCHER Before operating the unit, stand in the operating position. Check for the following: • Operator is wearing proper clothing, such as boots, safety glasses or goggles, ear/hearing protection, gloves, long pants and a long sleeve shirt. WARNING To avoid serious personal injury, wear goggles or safety glasses that comply with ANSI Z87.1at all times when operating this unit. Wear a face mask or dust mask in dusty locations. WARNING To prevent serious personal injury or damage to the unit, make sure the blower tube or the mulcher tubes and the bag are in place before operating the unit. Item 62337 15 For technical questions, please call 1-888-866-5797. Page 15