Harman Kardon Sabre SB 35 Owners Manual - Page 13
Programming SABRE SB35 to Respond to Your TV, Remote, Resetting Factory Default Settings - soundbar system
View all Harman Kardon Sabre SB 35 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
SB35 Programming SABRE SB35 to Respond to Your TV Remote Subwoofer Phase Adjustment (0-180°) This switch determines whether the subwoofer's piston-like action moves in and out in phase with the speakers in the soundbar. If the subwoofer were to play out of phase with the soundbar speakers, some of the sound waves produced by the soundbar and subwoofer could be canceled out at some frequencies, reducing the bass performance and sonic impact. This phenomenon depends on the relative placement of all the speakers in the room up to some extent. Programming SABRE SB35 to Respond to Your TV Remote You can program the SABRE SB35 to make it respond to your TV remote's power, mute, volume up and volume down commands. This programming lets you control your whole system with your TV remote. Before beginning to program the SABRE SB35, have your TV remote in hand. We recommend sitting down in front of the soundbar. NOTE: Some steps will time out, so read through this entire procedure before you begin. Have the TV remote in hand. When you start programming the remote, be ready to aim the TV remote control in front of the soundbar from about 300 mm - 900 mm (about 12 - 36 inches) away. To program the power, volume down, volume up and mute commands: 1. Ensure that the SB35 is switched ON. 2. Press the Power button on the soundbar and press the power button on the TV remote control. 3. Press the Volume + button on the soundbar and press the Volume + button on the TV remote control. 4. Press the Volume - button on the soundbar and press the Volume - button on the TV remote control. 5. Press the Volume + and Volume - button on the soundbar simultaneously and then press the Mute button on the TV remote. NOTE: If you would like to program a new TV remote control or you are missing a command, restart the whole process. If you would like to cancel the learning, reset the SB35. Put the SB35 in Standby mode, press and hold the Surround and Volume - button simultaneously. Once factory defaults are restored, the SB35 surround button will flash white for one second, then the unit will enter into operational mode. Resetting Factory Default Settings If you want to restore all the settings to factory default setting, press Surround and Volume - keys in standby mode. The factory default setting values are shown in the table below. 30 mm (12'') Tv Remote Item Source System Volume Surround Mode WAVE Value Optical -20dB Stereo Medium 13