Harman Kardon T45 Owners Manual - Page 3
Features, General, Instructions
View all Harman Kardon T45 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
FEATURES ■ High Mass Platter To provide low wow and flutter and smooth, consistent rotation, a 2.2 pound (1 .0 kg) platter is employed. ■ Solid Wood Base The base is 1-1/4 inches (30 mm) thick and composed of high density particle board. This results in a construction that is both rigid and vibration-absorbent. Its higher mass also reduces acoustical interference. ■ High Compliance Foam-damped Suspension Large, high compliance springs and foam-damping material in each of the four feet effectively isolate the base from mechanical vibration and shock. ■ Auto-lift Operation As the tonearm reaches the end of a recording, an optical photo-sensor activates the cueing lever and shuts off all power. This feature provides both the sound quality of a manual tonearm and the convenience and protection of automatic-return systems. ■ Optimum Tracking Geometry The effective tonearm length, stylus overhang and offset angle have been precisely determined to provide the lowest possible harmonic distortion over the total playing area. ■ Low Mass Straight Tonearm An effective mass of 8 grams assures excellent tracking with a wide range of medium to high compliance cartridges. ■ Frequency Generator Servo-controlled Motor A precision DC servo motor maintains correct speed by supplying the control circuit with a feedback correction signal . This minimizes speed drift caused by time, temperature and other external factors. ■ Capacitance Trim A selector has been provided so that the load impedance can be adjusted to ensure the optimum cartridge performance. ■ Vibration Absorbent Platter Mat and Disc Stabilizer A special rubber compound, featuring several thousandths of the rebound coefficient (bounce} of typical rubber, absorbs platter vibrations that would normally be transmitted to the record and stylus tip. Used in conjunction with the disc stabilizer, acoustic feedback disc jitter is greatly reduced. ■ Adjustable Feet This feature permits the user to precisely adjust the height of each foot for a level platter position. GENERAL INSTRUCTIONS Always Use at 120V AC This unit is designed for operation with 1 20V AC. Connect only to domestic AC outlets. Never connect the unit to an outlet supplying a higher voltage. This may create a fire hazard. Handle the Power Cord Gently • Do not disconnect the plug from the AC outlet by pulling the cord; always pull the plug itself. Pulling the cord may break the wire. • If you do not intend to use your unit for any considerable length of time, disconnect the plug from the AC outlet. • Do not place furniture or other heavy objects on the cord, and try to avoid dropping heavy objects on it. Also do not make a knot in the power cord. Not only may the cord be damaged, it can also cause a short circuit and a consequent fire hazard. Place of Installation Place your unit on a firm and level surface. Avoid installing your unit under the following conditions: ► Moist or humid places. ► Places exposed to direct sunlight or close to heating equipment. ► Extremely cold locations such as those in the direct draft from an air conditioner. ► Places subject to excessive vibration or dust. ► Poorly ventilated places. Moving the Unit Before moving the unit, be sure to unplug the power cord from the AC outlet and disconnect the interconnection cords to other units. Do Not Open the Cabinet To prevent fire or shock hazard, do not tamper with internal components for inspection or maintenance. Harman Kardon does not guarantee against performance degradation resulting from any modification. If water, a hairpin or wire accidentally enters the unit, immediately unplug the power cord from the AC outlet to prevent shock and consult an authorized Harman Kardon service station. If you use the unit under this condition, it may cause a fire or shock hazard. Cleaning When the unit gets dirty, wipe it with a soft dry cloth. if necessary, wipe it with a soft cloth soaked with mild soapy water and then wipe with a dry cloth. Never use benzine, thinner, alcohol or other volatile agent, and avoid spraying an insecticide near the unit. 2