Harman Kardon TD4800 Owners Manual - Page 6

OPERATING INSTRUCTIONS Inserting a Tape 1. Check cassette tape for excessive slack. If necessary, insert a pencil into one of the cassette hubs and rotate to take up slack. 2. Press Eject. 3. Insert cassette, tape side down, and close compartment door. NOTE: The cassette deck determines the type of tape in use and sets Bias/ Equalization circuitry automatically. Playing a Tape 1. Determine if tape was recorded using Dolby B, C or S Noise Reduction; press corresponding button on cassette deck. 2. Press ► to begin play. 3. If desired, adjust volume to headphones and receiver/pre-amp/ integrated amplifier by turning Output knob. 4. Press Replay if desired. ("Replay" will appear on Display panel.) When end of tape is reached, cassette deck will rewind tape to start and begin replaying automatically. Previewing a Tape 1. Press Intro Scan. Cassette deck locates the beginning of recorded material and plays for 15 seconds. Tape is then advanced to the beginning of each successive recorded segment, or track, playing for 15 seconds before automatically advancing to the next track. 2. To stop Intro Scan, press • (Stop). Or, press o. during any 15-second play segment, and tape will continue to play. Locating Places on a Tape 1. Using Skip Forward/Reverse. To move quickly to the beginning of any desired selection, use the Skip Reverse and Skip Forward buttons (i4ii and at upper right corner of the deck). a. Pressing Ai rewinds the tape to the beginning of the current selection. "P 00" is displayed to indicate this selection. b . To locate the beginning of a previous selection, repeat pressing 144. Display shows "P-01," "P-02," "P-03," etc., to indicate first, second, third selection previous to the original selection. c. To locate the beginning of the selection following the original selection, press . "P 01" is displayed. Continue pressing ood to locate subsequent selections (designated "P 02," "P 03," etc.).