Hayward Ecommand W/2Gva/Base/Aquaconne ECOMMAND-4-Operation-Manual-092420ARevF - Page 3

Introduction System Overview The ECOMMAND 4 is a multifunction pool controller used to fully manage your pool/spa system. The ECOMMAND 4 can control pumps, valves, lighting, heaters, and chlorination. Although the ECOMMAND 4 is easy to use, it is important to completely read through this operating manual before attempting to operate the control. Optional Wireless Spaside Remote G LD LINE C O NTRO LS INC . POOL VALVES SPA ON FILTER OFF ON HEATER OFF ON LIGHTS OFF ON AUX1 OFF ON AUX2 OFF Android/iOS mobile devices Optional Wireless Base Receiver Optional External Chlorinator (requires Aqua Rite) Main Display Keypad Computers Water Temperature Sensors Air Solar Filter Pump Lights Aux 1 120/240V Relays Aux 2 Pool/Spa Suction & Return Valves Valve 3 24V Valve Actuators Heater 240 VAC Power Circuit Breaker Subpanel NOTE: This manual assumes that the ECOMMAND 4 has been wired and configured according to the Installation Manual. Aspects of the ECOMMAND 4 that pertain to system setup are not covered in this manual. Automation The ECOMMAND 4 can control up to 4 high voltage (120/240V) pieces of equipment, up to 3 automatic valve actuators, and a conventional and solar heater. Both manual and automatic (programmed) operation are available. All of the control functions are programmed at the unit's display/keypad. Although the ECOMMAND 4 has no built-in chlorinator feature, it can control an external Hayward Aqua Rite or Hayward Swimpure chlorinator. 2 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS