Hayward HPC4-ACT-AQC ECOMMAND-4-Operation-Manual-092420ARevF - Page 11

Pool High Speed 100% Adjust the desired high speed for variable speed operation Move to previous/next menu item This setting will appear if "spa only" is not selected and variable speed filter pump is enabled. This setting determines the speed of the pump during high speed pool or spillover operation. This value can be set from 20% to "Highest Speed" in 5% increments. "Highest Speed" is default. Pool Low Speed 50% Adjust the desired low speed for variable speed operation Move to previous/next menu item This setting will appear if "spa only" is not selected and variable speed filter pump is enabled. This setting determines the speed of the pump during low speed pool or spillover operation. This value can be set from "Lowest Speed" to 50% in 5% increments. 50% is default. Set Day and Time Wednesday 1100::3377PP Adjust the current day of the week Move to hours setting Set Day and Time Wednesday 37 Adjust the current hour (including AM/PM if applicable) Move to minutes setting Set Day and Time Wednesday 10: P Adjust the current minute Move to previous/next menu item Use this function to set the current day of the week and time. These values are used for all the automatic timeclock functions of the ECOMMAND 4 and are also displayed as part of the default menu. The ECOMMAND 4 is designed to keep the clock running during power outages lasting less than 7 days. If power has been off for longer than 7 days, then the time may have to be reset. Display Light On for 60 sec Toggle between Always On and On for 60 sec. Move to previous/next menu item This function controls the backlight on the display. If the "60 seconds" option is selected, then the backlight will automatically turn off 60 seconds after the last key is pressed and will stay off until next time a key is pressed. NOTE: Display Light selection only applies to the display keypad that you are currently using. Other display/keypads will not be affected. In other words, you need to individually set this option for each display/keypad in the system. Beeper Enabled Toggle between Enabled (default) and Disabled Beeper Move to next menu item When "Enabled", the keypad will beep every time a key is pressed. If this audible indication is not desired, select "Disabled". This function only applies to the display/keypad that you are currently using. You need to set this option for each display/keypad in your system. NOTE: This function is not supported on all display/keypads. If the "Enabled" selection is not blinking, then the current software revision of that particular keypad/display does not support the option and it will default to Beeper Enabled. 10 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS