Hayward HYDRAPURE HydraPure Owners Manual - Page 7
Position the HydraPure Lid
 |
View all Hayward HYDRAPURE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Corded: Use Kit Number HYDRACORDKIT (sold separately) for 120V corded installation. Follow steps 1 & 2 below. L1 N Ground 1 Remove the lid by following the instructions on the bottom of this page. To install the HYDRACORDKIT, attach wires to connections according to the illustration above. 2 Plug HydraPure into a GFCI outlet. Position the HydraPure Lid The lid can be positioned in either of two directions for better view of the control panel. 1 R emove the 4 screws and then care- fully lift the lid. 2 R otate the lid and replace it in the desired position. Replace the 4 screws. CAUTION: Be aware that there is a delicate control ribbon cable under the lid. Take care when handling. 6 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
1
Remove the 4 screws and then care-
fully lift the lid.
2
Rotate the lid and replace it in the desired
position. Replace the 4 screws.
CAUTION:
Be aware
that there is a delicate
control ribbon cable
under the lid. Take
care when handling.
Corded:
Use Kit Number HYDRACORDKIT (sold separately) for 120V corded installation. Follow steps
1 & 2 below.
Position the HydraPure Lid
The lid can be positioned in either of two directions for better view of the control panel.
1
Remove the lid by following the instructions on the bottom
of this page. To install the HYDRACORDKIT, attach wires to
connections according to the illustration above.
L1
N
Ground
2
Plug HydraPure into a GFCI outlet.
6
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS