Hayward NorthStar All NorthStar models - Page 7

NorthStar™ Pump Series Page 7 of 15 Electrical (cont'd.) Wiring WARNING - All electrical wiring MUST be in conformance with all applicable local codes, regulations, and the National Electric Code (NEC). Pump MUST be permanently connected to circuit. If other lights or appliances are also on the same circuit, be sure to add their amp loads before calculating wire and circuit breaker sizes. Use the load circuit breaker as the Master On-Off switch. Motor Specifications Max Rate (MR) HP KW 1 0.75 1-1/2 1.10 2 1.55 2-1/2 1.87 3 2.20 - - Full Rate (FR) HP KW 3/4 0.55 1 0.75 1-1/2 1.10 2 1.55 - - 3 2.20 Voltage 208-230 115 208-230 115 208-230 115 208-230 208-230 208-230 60 Hz, 1 PH Amps 10A 15A 15A 20A 15A 30A 20A Wire Size 14 AWG 14 AWG 14 AWG 12 AWG 14 AWG 10 AWG 12 AWG 20A 12 AWG 30A 10 AWG Start-Up & Operation Prior to Start-Up NOTE - If it is necessary to perform a pressure test, prior to initial use to ensure pump is functioning properly, then the following criteria should be maintained for this test: 1. Have a professional perform this test. 2. Ensure all pump and system components are sealed properly to prevent leaks. 3. Remove any trapped air in the system by fully opening filter manual air relief valve until a steady stream of water (not air or air and water mix) is discharged from the valve. 4. Allow no more than 50 psi (345 kPa) at a water temperature no higher than 100° F (38° C). 5. Run pressure test for no longer than 24 hours. Immediately inspect all parts to verify they are intact and functioning properly. WARNING - If pump is being pressure tested (50 PSI MAXIMUM), be sure pressure has been released, using the filter manual air relief valve, before removing strainer cover. WARNING - All suction and discharge valves MUST be OPEN, as well as filter air relief valve (if available) on filter, when starting the circulating pump system. Failure to do so could result in severe personal injury. Starting/Priming the Pump Fill strainer housing with water to suction pipe level. If water leakage occurs from anywhere on the pump or filter, DO NOT start the pump. If no leakage occurs, stand at least 10 feet from pump and/or filter and proceed with starting the pump. WWW.HAYWARDPOOL.COM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS